SEH ThinPrint TPR-11 Quick Installation Manual

Text of the manual

Quick Installation Guide

1 � Monday - Thursday Friday 8:00 a.m. to 4:45 p.m. and 8:00 a.m. to 3:15 p.m. (CET) ℡ +49 (0)521 94226-44 @ [email protected] ThinPrint®Reader TPR-11 Quick Installation Guide Overview [en] This Quick Installation Guide provides a description of the installation of the TPR-11. It contains the following information: � General Info

Quick Installation Guide

Date of Manufacture The serial number includes the date of manufacture. The serial number can be found on the type plate.

Quick Installation Guide

[en] 3 2 General Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Purpose . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Scope of Supply . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Technical Data . . . . . . . .

Quick Installation Guide

� General Information Purpose The ThinPrint®Reader 'TPR-11' is an authentication hardware that allows you to use network printers as Personal Printing printers independent of printer make and model. This is done by transparently integrating the TPR-11 into the existing infrastructure. Authentication for the fetching of prin

Quick Installation Guide

[en] 5 Technical Data * The shield connection of the RJ-45 network connector is connected to the shield of the device port. This connection must be taken into account when arranging your network cabling. For more information, please consult your retailer. Properties Values Printer port logical: physical: - IEEE 802.3 - RJ-45 (STP Ca

Quick Installation Guide

LED Display The LEDs of the TPR-11 give you information about its status. - ISO/IEC 14443 type A (13.56 MHz): Legic advant, MIFARE Classic 1K/Classic 4K/Classic Mini/ DESFire EV1/Plus S/Plus X/Pro X/SmartMX/Ultralight/ Ultralight C, PayPass, SLE 44R35/66Rxx (my-d move) - ISO/IEC 14443 type B (13.56 MHz): Calypso, CEPAS, HID iC

Quick Installation Guide

[en] 7 Smart card reader status permanently off permanently on lighting up once (1 s) lighting up once (1 s) - green green red An error occurred on the smart card reader. The smart card reader is ready to operate. A card is recognized on the smart card reader. NOTE: In addition, you will hear a short beep. A card is not recognized on

Quick Installation Guide

� Safety Regulations TPR-11 are network devices for use in office environments. They are used as authentication hardware for Personal Printing printers in TCP/IP networks. Before starting the initial setup procedure and during the operation of the TPR-11, please note the following safety regulations. Their purpose is to prot

Quick Installation Guide

[en] 9 � Hardware Installation The TPR-11 is placed transparently between the printer and the network. before after Proceed as follows: 1. Remove the printer network cable (RJ-45) from your switch. 2. Connect the removed printer network cable (RJ-45) to the network connector marked as 2 Printer on the back of the TPR-11. 3. Connect

Other Printer Manuals