SIG Rascal 80 eg Assembly Manual

legend of the RASCAL began with a small rubber powered free-flight model in the 1950s. Adapted for modern radio control, the RASCAL's classic good looks and dream-come-true flying characteristics have made it the favorite everyday airplane of thousands of R/C pilots. SIG o ...

find that 5000mAh LiPo packs provide between 10 to 15 minutes of flight time, depending on propeller selection and other factors (quality of pack, throttle management, outside temperature, etc.). CAUTION: You must match your propeller size to the cell ...

❑ (1) Fuel Tank Body - 295cc (10 oz.) ❑ (1) Rubber Stopper ❑ (1) M3 x 34mm Bolt ❑ (1) Metal Clunk Pick-Up ❑ (3) Plastic Tube - 4mm od x 60mm ❑ (2) Zip-Ties ❑ (1) 5/16" x 3/4" x 3-3/16" Balsa Fuel Tank Retainer Engine Mounts for Glow Engine ❑ (1) Right Nylon Engine Mount ❑ (1) Left Nylon Engine Mount ❑ ...

wing panels joined by an aluminum tube wing joiner and a hardwood locating pin at the rear. Due to the high strength of the wing joiner tube, the wing panels do not need to be permanently glued together. Gluing them permanently together is optional – it’s your call. ...

this process until you have glued both sides of all the hinges! Keep a rag handy to wipe off any excess thin CA glue. (If you get some glue smears on the plastic covering, don't worry about them right now. Once all the hinging is done, you can clean the smears off the covering with CA ...

Locate the following parts from the kit contents: (1) Fuselage (1) Aluminum Main Landing Gear (3) M4 x 20 mm Socket-Head Bolts (3) M4 Split-Ring Lock Washers (2) 3" dia. Main Wheels (2) 4 mm dia. Axles with threaded bolt Head (2) 8 mm Hex Nuts; for axles (4) 4 mm ID Wheels ...

(2) Coiled Steering Springs (1) Steering Arm (2) M3 x 12 mm Screws (2) Split Lock Washers (3) Nylon Control Horns (1) Nylon Control Horn Retaining Plates (6) M2 x 14 mm Screws (6) M2 Nuts ❑ 11) Remove the elevator and hinges from the horizontal stabilizer, ...

with thin CA. ❑ 17) Look closely and you will find three holes pre-drilled near the bottom of the rudder for mounting the nylon control horns. Run a 5/64” Drill through the three holes. Install the Pull-Pull control horns o ...

the tailwheel horn. ELEVATOR & RUDDER CONTROLS For this section you will need: (1) Fuselage Assembly (1) Elevator Pushrod with M2 Hex Nut (1) Metal RC Clevis (1) Small pieces of Fuel Tubing (1) Pull-Pull Rudder Kit (1) ...