ZIGBEE WZB-05ET Operation & User’s Manual

Ver. 1.03 Copyright 2011-14 Nietzsche Enterprise Co., Ltd. All rights reserved. Nietzsche Enterprise reserves the right to make changes and improvements to its products without notice. Contact Information: Email: [email protected], Website: www.shop-wifi.com/wireless-sensors Content 1) Package Content and ...

2 Congratulations for choosing a world-class digital temperature and humidity sensor using ZigBee wireless transmission technology. This manual is designed to help set up and get the most from the sensor in a few short minutes. Safety notice: Please read and follow the instructions before using this product  To prevent electrical ...

3 2 Installing Mounting for WZB-05ET Requirements:  Mounting fixtures  Drill with 5mm (0.2 inches) drill bit size (if using wall plugs) or 3.5mm (0.14 inches) drill bit size (if not using wall plugs)  Size 1 Phillips screwdriver a) Locate WZB-05ET within 1.0m of AC mains socket and with at least 15cm (approx.. 6 inches) spac ...

4 3 Powering On WZB-05ET Requirements:  DC 5V USB adapter and cable a) Connect USB cable’s Standard-A plug to DC 5V USB adapter and plug into live AC Mains socket. b) Connect USB cable’s Micro-B plug to WZB-05ET. c) The status LED on WZB-05ET should start flashing. WZB-05ET has been successfully powered on. Recommendation: It ...

5 that will not cause conflict, (eg. 10010) if WZB-05ET will not be networked → click “Submit” to make the changes as shown below. g) Click on “Miscellaneous Setting” on the left side of the screen. → Update the “IP Address Selection” details with the reserve IP address and other network configuration obtained from th ...

6 5 Enabling WZB-05ET to Permit Join Other Devices to its Network Requirements:  Child device, such as router (eg. STH-M02ZB, WZB-01USBR, WZB-02485R), or end device (eg. STH-01 series, STH-M02ZB, STH-03ZB, S05 series)  Sharp pointed tool a) Ensure WZB-05ET is powered on (see “Powering On WZB-05ET”) and ready to receive data ...

7 Recommendation: Open the DavaView before joining sensors to WZB-05ET to confirm with joined sensors. 6 Removing Devices from WZB-05ET Requirements:  Child device, such as router (eg. STH-M02ZB, WZB-01USBR, WZB-02485R), or end device (eg. STH-01 series, STH-M02ZB, STH-03ZB, S05 series)  Sharp pointed tool a) Ensure WZB-05ET is ...

8 b) LED light should show Reset status (Blue & Red light for 3 seconds). → Blue LED light should return to Ready status (1 blue flash repeated in 1 second interval) c) All connected devices stored in WZB-05ET have been disconnected. Note: Devices that were stored in WZB-05ET before the reset process are now “orphaned” and need ...