SilverStone DS222 Manual 

Text of SilverStone DS222 Manual 

Compact dual-Bay 2.5" HDD/SSD enclosure with RAID 0/1/BIG capability

DS222 Storage dual-Bay 2.5" HDD/SSD enclosure with RAID 0/1/BIG capability DS222

With 2.5” drives closing the gap on 3.5” drives in terms of capacity and cost, they are now also viable as solution for backup and desktop

storage while maintaining significant size advantage over 3.5” drives. To capitalize on this changing of trend, SilverStone created the DS222 dual bay 2.5” USB 3.0 RAID enclosure for those looking to use 2.5” HDD or SSD as their storage of choice. DS222 co

Minimum Intel Pentium III CPU 500MHz, 128MB RAM

Windows XP, Windows Vista, Windows 7, Windows 8/8.1, Linux Corresponding port on your host device (e.g. USB 3.0/USB 2.0 port) 1.1.2 Mac Minimum Apple G4 processor, 128MB RAM Mac OS 10.4 or above Corresponding port on your host device (e.g. USB 2.0 port*) 1.1.3 Supported Hard Drives One or two 2.5" SATA-I, SATA-II or SATA-III Hard drives (1.5Gb/s or 3.

1. In order to determine if the correct mode is selected, please ensure the RAID switch is in the correct position.

2. If drive failed in any mode, the alarm (buzzer) will sound to warn users. Status Red = Power on Blue = hard drive detected , Flashing = Data access (read/write), Off = HDD failed or empty drive bay Blue = hard drive detected , Flashing = Data access (r

2.1 Hard Drive Assembly

The drives can be installed at any position, there is no specific order required. 1.Unlock the switch at the bottom of the case and lift the front panel upward and away from the housing to remove it. 2.Install the hard drives in the direction as illustrated. Set your preferred RAID mode and then replace the front panel. ※ The default RAID mode is Non-Raid, if you wish to change the RAID mode,

2.2 RAID Modes Setting

RAID refers to redundant array of independent disks. It is a storage technology that combines multiple disk drive components into a logical unit. Data is distributed across the drives in one of several ways called "RAID levels", depending on the level of redundancy and performance required. 2.2.1 Non-RAID The two hard drives show independent volumes, each drive can be formatted and accessed separ

Before connecting the device, install the hard drives and set RAID mode.

Always follow the correct unplug procedure for external hardware (e.g. Eject in the OS before removal) to avoid risk of data loss. Do not damage any components and force the drives into place. If the drive is hard to slide in, make sure the SATA connector is in right position. Hard drives in excess of 2.2TB require change to GPT partit

3.6 Data Backup

In order to prevent risk of data lose, we strongly recommend backing up your data in another storage media or device. Please backup hard drives data before changing RAID mode. 3.5 Cables Use only the cables supplied or recommended by your vendor in order to avoid the risk of malfunction, electric shock, and/or possible interference to the device. 3.7 FAQ Q: Can I connect this device to a USB 2.0 host? A: Yes

SilverStone Enclosure Owners Instructions: