SMC Networks PSE550 Operation Manual

Safety Instructions 2 Model Identification and How to Order 8 Definition and terminology 8 Mounting and Installation 9 Piping 9 Wiring 9 Troubleshooting 11 Specification 12 Specifications 12 Dimensions 14 ...

These instructions indicate the level of potential hazard with the labels of "Caution", "Warning" or "Danger". They are all important notes for safety and must be followed in addition to International Standards (ISO/IE ...

The product herein described is basically provided for peaceful use in manufacturing industries. If considering using the product in other industries, consult SMC beforehand and exchange specifications or a contract if necessary. If anything i ...

equipment, and have sufficient knowledge of assembly, operation and maintenance of such equipment. Only those persons are allowed to perform assembly, operation and maintenance. Read and understand this operation manual careful ...

●The instructions on design and selection (installation, wiring, environment, adjustment, operation, maintenance, etc.) described below must also be followed. Product specifications The direct current power supply to combine sh ...

In particular, never lift a Pressure Sensor equipped with fitting and piping by holding the lead wires. Avoid repeatedly bending or stretching the lead wire, or placing heavy load on them. Repetitive bending stress or tensile stress can cause the sheath of the wire to peel off, or breakage ...

Do not short-circuit the load. If using the product to detect very small pressure rates, warm up the product for 20 to 30 minutes first. There will be a drift on the analogue output of approximate 1% immediately after the power supply is turned on, within 10 minutes. Maintenance Turn off th ...

○Option Description Part number Remarks Bracket ZS-30-A With M3x5 L (2 pcs.) Connector for pressure sensor controller ZS-28-C 1 pc. ■Definition and terminology Terms Meaning F F.S. (full span/full scale) Abbreviation for full span and full scale; means the maximum fluctuation range of the Pressu ...

■Piping ○Piping connections Cut the air tube perpendicularly. Grasp the air tube and insert it to resin firmly by 8 mm or more from the end the resin piping. The pulling force necessary for the piping inserted by 8 mm or more is approximate 25N. Insert the air tube for low pressure to Lo piping ...