Wallpro CG-600L Operating Instructions Manual

Text of the manual

The appliance is not intended for use by young children or infirmed persons unless they have been

adequately trained by a responsible adult to ensure that they can use the appliance safely and without supervision. 2. Young children should be supervised to ensure that they do not play with the appliance. 3. Consider work area environment. Do not expose t

Caution: To reduce risk of injury, change only specific type rechargeable batteries. Other types of

batteries may burst causing personal injury and damage. 2. Before using battery charger, read all instructions and cautionary markings on the batteries and chargers. 3. Do not expose charger to rain or snow. 4. To reduce the risk of damage to electric pl

View of the Major Components & Accessories

Model No CG-600L Voltage 10.8V DC Capacity 600ml Expel Force 392kgf Impacts Per Minute 3000 Tool weight (with battery) 2.335kg (battery 0.185kg) No Load Speed 6.1mm/sec Charging Time 35 minutes – Auto Cut-off Performance 45 tubes of 225mm (9”) silicone for a fully charged battery at room temperature Specificatio

Installing or Removing Battery Pack (See Fig.1 Fig.2 )

1. Always switch off the machine before insertion or removal of the battery pack. 2. To remove the battery pack, pull out the set plate on the machine and grasp both sides of the battery pack while withdrawing it from the machine. 3. To insert the battery pack, align the tongue i

The LED Light on the Charger

Power On (Green light flashes slowly) Battery�Low�(Red�light�stays�illuminated) Battery charged 80% (Green light flashes rapidly) Battery charged 100% (Green light stays illuminated) Battery�Pack�temperature�is�too�hot�or�too�cold�(Red�light�flashes�slowly) Battery�Pack�malfunction�(Red�a

Tool Operation – for Sausage Bag Application

1. Cut a hole in one end of the sausage bag as shown in the figure below. 2.� Remove�the�front�cap.�Fit�the�nozzle�inside�the�front�cap�and�cut�off�the�tip�at�a�point�suitable�for�the� job. 3. Insert the sausage bag into the compound holder. Screw the front cap on t

Tool Operation – for Cartridge Application

1. Loosen and remove compound holder. 2. Loosen M8 Screw then remove the plastic plunger disk. Rack Plunger Disk Front Cap Compound Holder Plastic Plunger Disk Rack Plunger Disk M8x16 Screw

Other Caulking Gun Manuals