Webasto Thermo Top E Installation Instructions Manual

in the emission of carbon monoxide, which can be fatal. Serious or fatal injuries can be caused as a result. Specialist company training, technical documentation, specialized tools and equip- ment are required to install and repair Webasto heating ...

Validity Vehicle and engine types, equipment variants and national specifications not listed in these installation instructions have not been tested. However, installation according to these installation instructions may be possible. The installation location of a digital timer and summer/winter switch should be confirmed with ...

Heater Unit/Installation Kit Heater unit recommended for the respective vehicle class: The selection of the heater unit is based on the passenger compartment size of the vehicle and the level of comfort required by the customer! Foreword These installation instructions apply to Nissan Pathfinder and Navara vehicles with 2.5 lit ...

Mechanical work Electrical system Coolant connection Fuel connection Exhaust system Combustion air The arrow in the vehicle icon indicates the position on the vehicle and the viewing angle. Nissan Pathfinder and Navara Specific risk of injury or fatal accidents. Specific risk of damage to compon ...

Preliminary Work WARNING! - Copy the factory number from the original type label to the duplicate type label. - Remove years that do not apply from duplicate label. - Attach the duplicate label (type label) in the appropriate place. - Open the fuel tank cap and vent the fuel tank. - Close the tank cap again. - Disconnect and re ...

Preparing electrical system All equipment Cutting wire to length Produce connections as shown in wiring dia- gram. Cut included protective sleeving to length of 2,500 and push onto wire . Only with passenger compartment moni- toring Also connect 3,000 mm long red (rt) wire to K3/86 and pull into protective sleeving. Connect- in ...

Electrical Connections Fuse holder, relay K3 WARNING: Do not damage tank (1) 6.5 mm dia. hole Fuse holder, relay K3 (3) M6x12 bolt, angle bracket, flanged nut (4) Retaining plate, M5x12 bolt, large diameter washer, flanged nut (5) Fuse holder mounted (2) K3 relay, M5x12 bolt, large diameter washer, flanged nut (1) Positive wire ...

Remote option (Telestart) (1) Receiver (2) 4 mm dia. hole; 5.5x13 self-tapping screw [2x] Installing receiver Produce all connections in accordance with general installation instructions provided and fasten wires with cable ties. (1) Antenna Installing antenna 1 2 7 2 1 8 i ...

Remote option (Thermo Call) (1) Receiver (2) 4 mm dia. hole; 5.5x13 self-tapping screw [4x] Installing receiver (1) Antenna Installing antenna Produce all connections in accordance with general installation instructions provided and fasten wires with cable ties. (1) Push button Installing push but- ton 1 2 9 2 1 10 1 11 i ...

Fan controller for manual air conditioning Wiring dia- gram for manual air condition- ing Webasto components Nissan components Colors and symbols Legend HG Heater unit GM Fan motor rt red X1 6-pin heater unit con- nector gr Fan relay ws white F3 25 A fuse WG Resistor group sw black K3 Fan relay M95 4-pin connector WG br brown ...