Proline PGH465GM-N Operating And Installation Instructions

2. SAFETY INSTRUCTIONS 3. INSTALLATION 4. USAGE 5. MAINTENANCE & CARE ...

recommendations in these instructions are for your own safety and that of others. They will also provide a means by which to make full use of the features offered by your appliance. Please keep this booklet in a safe place. It may be useful in future, either to yourself or to others in the event that doubts should arise relating to its operation. This appliance mus ...

2. Pan support 3. Burner cap 4. Burner body 5. Control knob 8 6. Rapid burner 7. Semi-rapid burner 8. Auxillary burner 9. Base cover 2 1 DESCRIPTION OF THE HOB 1 2 3 6 7 4 5 ...

BEFORE USING THE APPLIANCE The adjustment conditions for this appliance are stated on the rating label. This appliance shall be installed in accorance whit the regulations in force and only used in a well ventilated space. Read the instructions before using or installing this appliance. Appliances should be electrically Problems due to to improper connection are not covered by the warranty. This appliance ...

DISTRIBUTION CONDITIONS AND THE ADJUSTMENT OF THE APPLIANCE ARE COMPATIBLE. This appliance must be installed by a qualified gas installer who must also be a qualified electrician if the appliance requires connecting to a mains electricity supply. After removing the packaging material from the appliance and its accesories ensure that the hob is not damaged. If you suspec ...

100 mm from edge of cooker to combustible materials. 0 mm underside of overhead cupboards, shelving 750mm underside of overhead exhaust fans. This appliance must be installed according to the manufacturers installation instructions, local building regulations, gas authority codes and electrical wiring instructions. The gas feeding manifold protruding from the back of the hob ...

D type connection in United Kingdom and Ireland, the flexible gas hose should neither pass behind an n be in contact with may cause combustion. • with o • . • • • • . • Minimum distance between the appliance and combustible premises must be 20 mm • After the connection had been it has to be tested. • This test can be done by applying a soapy liquid to the connection. No bubble should appear. If there are bubbles, ...

Min.Rating (kw) Consumption in 1h Consumption in 1h (at 150C and 1013mbar press) AUXILLARY BURNER Injector diam.(%mm) Nominal Rating (kw) Min.Rating (kw) Consumption in 1h Consumption in 1h (at 15 0C and 1013mbar press) MEDIUM BURNER Injector diam.(%mm) Nominal Rating (kw) Min.Rating (kw) Consumption in 1h Consumption in 1h (at 150Cand 1013mbar press) LPG G25 G30 28-30 mbar 85 3 0.85 218.13 ...

not in a room or space containing a bath or a shower. The appliance must not be installed in a bed-sitting room of less than 20 m . The appliance is designed and approved for domestic use only and should not be installed in a commercial, semi commercial or communal environment. Your product will not be guaranteed if installed in any of th ...

Neigboorhood walls Combustible Non-combustible A [mm] B [mm] 60 150 40 50 523mm 43.5mm Min. 25mm 490mm Min. A 594mm 560mm Min. B ...

• The current carrying capacity of the system and the socket is adequate for the maximum power rating of the hob. •The voltage indicated on the capacity label is the same as the supply voltage • Do not use for connection any reductions , adapters or shunts because they may cause overheating. •The socket has an earth terminal. Please ensu ...

Warning: This appliance must be earthed. The appliance must be connected to a 240 volts 50 cycle AC supply by means of a three pin socket, suitably earthed and should be protected by a 3 amp fuse in the plug. The appliance is supplied with a 13-amp 3-pin mains plug fitted with a 3 amp fuse. Should the fuse require replacement, it must be replaced with a fuse rated at 3 amp and approved to BS1362 The plu ...

Manual Ignition Ignition Through Control Knob (microswitch): To ignite one of the burners, approach a match to its upper circumference and push the corresponding conrol knob and turn it counter clock-wise. Medium regulation of the flame will be obtained by turning the control knob between maximum position (big flame) and the minimum position (small flame). The small diagrams situated on the control panel indicate to the gas bu ...

Transformation For The Gas Cookers Replacement Of Injectors GAS CONNECTION INJECTORS REPLACEMENT OF HOB BURNERS The installation of the gas appliance to natural gas or LPG must be carried out by a gas safe registered engineer. Engineers shall take due account of the provisions of the relevant British Standards Code of practice, the gas safety regulations and the building standards (Scotland) (Consolidati ...

which makes the flame of the burner reduce to the minimum. When the flame has a length of at least 4 mm, the gas is well distributed. Make sure that the flame does not die out when passing from the maximum position to the minimum position. After the adjustment is complate replace the rubber seal and replace the knob. o 13 ...

gas supply. Periodically, enamelled pan supports, enamelled covers, burner heads must be washed with soapy warm water rinsed and dried. After drying them thoroughly, replace them correctly in their placement. by closing the main CLEANING THE CERAMIC GLASS SURFACE • • Scraper available separately contact the store where you purchased this appliance • • • • ...

Calls are charged at standard rates. If there is something about your appliance which you do not understand and you live in the UK you can phone our help line during normal office hours on: 0844 8009595 If you require service, call the number on your sales receipt. We apologise for any inconvenience caused by minor inconsistencies in these instructions, which mayoccur as a result of product improvement and development. Kes ...

2. VEILIGHEIDSINSTRUCTIES 3. INSTALLATIE 4. HET IN GEBRUIK NEMEN VAN DE KOOKPLAAT 5. ONDERHOUD AAN HET APPARAAT ...