ProTeam ProForce 1200XP Manual 

Text of ProTeam ProForce 1200XP Manual 

Read Owner's Manual before using this product.

Failure to do so can result in injury or property damage.

7. Dust Brush

Combo de accesorios: cepillo/ boquilla para tapicería Brosse d’époussetage 8. Wand Tubo Tube-rallonge 9. Hose Manguera Tuyau 10. Owner’s Manual Manual Manuel du propriétaire 11. Quick Start Instructions Instrucciones de inicio rápido Instructions sommaires TABLE OF CONTENTS CONTENIDO TABLE DES MATIÈRES Important Safety Instructions / Instrucciones importantes de seguridad / Importantes mesures de sécurité ...............

Cuando se usa un artefacto eléctrico, siempre se deben seguir precaucio-

nes básicas, entre las que se incluyen las siguientes: Lea el Manual del Propietario antes de usar este producto. Para reducir el riesgo de incendio, descarga eléctrica o lesiones: 1. Utilice la aspiradora solamente como se describe en este manual. Utilice solamente los accesorios y repuestos recomendados. 2. NO deje ninguna aspiradora

Electric thru-flow vacuum motors must never be used in applications in which

wet or moist conditions are involved, where dry chemicals or other volatile materials are present, or where airflow may be restricted or blocked. Such motors are designed to permit the vacuumed/filtered air to pass over the electrical wiring to cool it. Therefore, any liquid (including water), dry chemi- cal, or other foreign substance which would come in con

THESE VACUUMS MUST BE GROUNDED. If a vacuum should malfunction or

stop working, grounding provides a path of least resistance for electrical cur- rent, thereby reducing the risk of electrical shock. This unit is equipped with a cord that has an equipment-grounding conductor and grounding plug. The plug must be inserted in an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinanc

1. Attach hose to vacuum by depressing the

quick release tabs. 2. Insert wand into wand port. 3. Insert the handle tube into the channel on the bag housing and press downward until it is 2-3 inches inside the channel. It will be correctly inserted when the handle bushing hole in the handle tube aligns with the nut plate hole in the bag housing. 4. Insert ratchet fastener into cord clasp opening by pushing with thumb to secure cord to handle. 5.

The panel on the front of the vacuum contains

the indicators (Figure A) listed below: BAG FULL (Figure A1) Indicator is lit red when Intercept Micro Filter should be changed. POWER NOZZLE ON (Figure A2) Indicator is lit green when power nozzle is turned on. JAMMED BRUSH ROLL (Figure A3) Indicator is lit red when brush roll is jammed. RESET SWITCH Press red reset switch to restart motor after clear- ing a blockage. (Figure B) ON/

COMBO TOOL (Figure A & Figure B) - works as a:

• Dusting Brush (Figure A) - for furniture, shelves, books, lamp bases, etc. • Upholstery Tool (Figure B) - for cushions and draperies. CREVICE TOOL (Figure C): • For crevices, air vents, corners, between cushions. CLOG-RESISTANT UNBREAKABLE WAND (Figure D): • For high areas, such as ceilings, and other hard to reach areas. USING WAND NOTE: If the ProForce 1200XP/1500XP power nozzle moto

CHANGING INTERCEPT MICRO FILTER

NOTE: Check and change Intercept Micro Filter frequently! (Figure A) 1. To open the filter bag cover, press the release button on top of the bag cover and open cover. 2. Remove the used Intercept Micro Filter from the vacuum and discard. Do not reuse bag. 3. Insert the new Intercept Micro Filter. 4. Close the cover and snap into place. CHANGING MOTOR INTAKE FILTER The motor intake filter is located under the Intercep

CLEARING THE BRUSH ROLL

Obstructions such as hair, string, and throw rugs may cause the red brush indicator light to be illuminated and the power nozzle to shut off. 1. Turn off vacuum and unplug power cord from outlet. 2. On underside of vacuum, pull out, or cut away, obstructions on the brush roll. (Figure A) 3. Press the reset button on top side of power- head. Plug-in power cord, and restart motor (Figure A). CLEARING HOSE & WAND

ProTeam Vacuum Cleaner Owners Instructions: