Prozeda Solareg II ENERGY Operating Manual

Operating manual Solareg II ENERGY ...

3 1.1 Application area 3 1.2 Device features 3 2 Safety instructions 3 3 Mounting the device 4 3.1 Opening the device 4 3.2 Wall mounting 4 3.3 Connections 5 3.4 Temperature sensor connection 5 4 Short descriptions and device operation 5 4.1 Display layout 5 4.2 Operating the device 6 5 Menu structure 6 5.1 "Inf ...

1.1 Application area The SOLAREG II ENERGY controllers are high-performance microprocessor-con- trolled units for controlling the functions of solar thermal systems. The SOLAREG II ENERGY perfectly controls solar power systems equipped with one collector and one storage tank. The controllers are designed for use in dry ...

3.1 Opening the device Prior to opening the device, make sure to disconnect the mains voltage and ensure that it cannot be switched back on again. The upper part of the housing is locked to the lower part using two latches. Pull the side pieces (cover plates) of the upper part of the housing outwards (see picture) to unlatch it and up ...

◼ In case of a fixed mains connection, there must be a switch installed outside the controller that can disconnect the device from the mains power supply. This switch is not required if the mains supply is connected using a cable and an earthed mains plug. The controllers a ...

The SOLAREG II controller is convenient and easy to operate using four operating buttons. Using the operating buttons, you can: Access display values ◼ ◼ Perform device settings The graphic display symbols allow you to easily navigate through the operating structure. The operating buttons have the following functions: Operatin ...

return line nein 1234 h Operating hours for charging storage tank Can be reset to 0 h Yes 927 kWh Energy yield for storage tank Can be reset to 0 kWh Yes 5.2 "Programming" menu The operating parameters are displayed and can be changed, if necessary, in the Programming menu. ...

The main functions are displayed in the Basic Setup menu. Settings must only be changed by a specialised technician. Settings may be adjusted only when you enter the menu within one minute after the device has been switched on. Display Meaning Value range Factory setting Current setting Line Value 0 0 Collector protection function 0 ...

230V connections L Mains phase N Neutral conductor - mains and outputs A1 Solar circuit pump (switching output 1) A2 Switching output 2 Sensor connections S1 Collector sensor S2 Lower storage tank S3 Thermostat S4 Collector return S5 Option: flow meter ...

The controller compares the temperatures of the various measuring points and op- timally charges the storage tank. If the collector temperature exceeds the storage tank temperature, the solar circuit pump is switched on. Monitoring and protection functions ensure safe operation. 7.1.2 RPM control The o ...