Vivotek SD9361-EHL Quick Installation Manual

Text of the manual

Quick Installation Guide

2MP • 20x/30x Zoom • 60fps • NEMA 4x • IP68 • Extreme Weatherproof SD9362-EH/EHL Speed Dome Network Camera English 繁中 日本語 Español Português 簡中 Français Deutsch Italiano Türkçe Polski Русский Česky Svenska Dansk Nederlands Indonesia SD9361-EHL

Warning Before Installation

Refer to your user’s manual for the operating temperature. Power off the Network Camera as soon as smoke or unusual odors are detected. Do not touch the Network Camera during a lightning storm. Do not disassemble the Network Camera. Do not drop the Network Camera. Do not insert sharp or tiny objects into the Network

IR unit connector

Lens Outer View Physical Description 2 LAN connector Status LED Reset Button This drawing shows a camera with its dome cover removed. MicroSD card slot Safety wire hook I/O combo connector Alignment marks

Ø 9.5mm or 3/8”

1. Jot down the camera's MAC address for later reference. 2. The camera weighs 3kg. Select a rigid mounting location to prevent vibration to the camera. Attach the alignment sticker to the wall. 3. Drill 4 pilot holes (9.5mm in diameter and 4cm deep) into the wall, and then hammer in threaded anchors. N

5. Connect power or I/O wires, and use foam tapes or seal foam to ensure the back-end

connection is waterproof. 6. Route your I/O combo and Ethernet cables along the routing guide poles to form drip loops.

7. Secure the bracket to wall.

15cm 8. Remove the cable gland from the LAN port. If I/O wires or 24V power are preferred, use the T20 L-wrench to remove the top cover on the I/O connectors. T20 The cable length hanging on the out- side of the bracket should be 15cm IMPORTANT: Make sure all waterproof cable glands have been properly installed. Wa

9. Hook up the safety wire between the bracket and the camera.

4.3 ~ 6.4mm 10. Install the components of the waterproof cable gland to the Ethernet and I/O com- bo cables. The outer jacket of the combo cable is flush with cabling hole.

11. Connect the I/O wire headers to camera and then secure the top cover.

T20 12. Connect the Ethernet cable (along with its cable gland) to the camera. NOTE: To disconnect a LAN cable, loosen the cable gland and pull the cable against the socket wall towards the side of the locking tab. 1 2

13. Install the camera to bracket by aligning the mark on bracket with the #1 marking

on the camera. 1 2 14. Turn the camera clockwise. The camera should be locked in place. 15. Secure the connection using the T25 L-wrench from the top. T25

16. Open the dome cover using the T20 L-wrench. Install a microSD card, and replace

the desiccant bag on the inner side of camera chassis. Micro SD T20 17. Remove the foam blocks in the chassis, and the front and rear of the lens module. Also remove the plastic sheet from the inside of the dome cover. 18. When done, secure the dome cover using t

Other Security Camera Manuals