BIXOLON SRP-270 Reference Manual

POS/Mobile Printer Rev. 1.00 SRP-S300 SRP-380/SRP-382 SRP-350plusIII/SRP-352plusIII SRP-350III/SRP-352III SRP-F310II/SRP-F312II SRP-350IIOBE SRP-330/SRP-330II SRP-340 SRP-150 STP-103III SPP-R200III/SPP-R200II SPP-R210 SPP-R310/SPP-R300 SPP-R400 SRP-275III/SRP-270/SRP-280 http://www.bixolon.com ...

■ Table of Contents 1. About This Manual ......................................................................................................... 3 1-1 Supported Kernel & Platforms .................................................................................... 3 1-2 Supported Interfaces ............................. ...

1. About This Manual This SDK manual describes the contents of the library required to develop Linux OS application programs. At BIXOLON, we are constantly making improvements to the functions and quality of our products. The specifications and contents of this manual are subject to change without prior notice for this reas ...

2. Property The constants used by the library are declared in bxlConst.c. The development environment is based on C. 2-1 CharacterSet (LONG R/W) This is the property for defining the printer's code page and set to BXL_CS_437 by default. The values can be set and read using SetCharSet() and GetCharSet(). The following code p ...

2-2 International CharacterSet (LONG R/W) This is the property for defining International character Set and set to ICS_USA by default. The values can be set or read using SetInternationalChar() and GetInternationalChar(). The following International character Set can be used: Constant Value Description ICS_USA 0 USA code IC ...

2-3 State (LONG R) This is the property that sets the printer status. It is read only and calls GetStatus() to read the printer status. The status value can be set in duplicate and each value can be checked using bitwise operation. These are the printer status values: Constant Value Description STS_NORMAL 0 The printer stat ...

3. Method The development environment is based on C. 3-1 ConnectToPrinter Set the connection for communication with the printer. int ConnectToPrinter(const char *port) [Parameters] * const char *port [in] Interface to be connected to the printer Interface Input Data Example USB USB: ConnectToPrinter(“USB:”) Serial seria ...

3-2 DisconnectPrinter Disconnect the printer. void DisconnectPrinter() [Parameters] None [Return Values] None * Example ConnectToPrinter(………..); …… DisconnectPrinter(); ...

3-3 InitializePrinter Cancel the existing settings and initialize. int InitializePrinter() [Parameters] None [Return Values] Constant Value Description SUCCESS 0 The function is successful. WRITE_ERROR -105 Data transmission failed. * Example …… InitializePrinter(); …… ...

3-4 LineFeed Line feed to the amount of the integer value set as a factor. int LineFeed (const unsigned int lineNum) [Parameters] * const unsigned int lineNum [in] Send the number of line feeding lines in an integer value as a factor. [Return Values] Constant Value Description SUCCESS 0 The function is successful. WRITE_ER ...