Anybus Wireless Bolt Startup Manual

Liability Every care has been taken in the preparation of this document. Please inform HMS Industrial Net- works AB of any inaccuracies or omissions. The data and illustrations found in this document are not binding. We, HMS Industrial Networks AB, reserve the right to modify our products in line with our policy of continuous produ ...

3 (16) 1 About This Document This document describes how to install Anybus Wireless Bolt and set up a basic configuration. For additional documentation and technical support, please visit the Anybus support website www.anybus.com/support. Trademark Information Anybus ® is a registered trademark and Wireless Bolt™ is a trademark of HMS ...

Medical) band. Make sure that all medical devices used in proximity to this device meet appropriate susceptibility specifications for this type of RF energy. This product contains parts that can be damaged by electrostatic discharge (ESD). Use ESD pr ...

through an M50 (50.5 mm) hole using the included sealing ring and nut. Tightening torque: 5 Nm ±10 % Make sure that the sealing ring is correctly placed in the circular groove in the top part of the housing before tightening the nut. All ...

Wireless Bolt. Pin 1 will be the pin closest to the button. Pin Name Description 1 VIN Power 9–30 VDC 2 GND Power Ground 3 DI Digital input (9–30 VDC) 4 DI_GND Digital input ground 5 ETN_RD+ Ethernet receive + (white/orange) 6 ETN_RD- Etherne ...

1. Cut off one of the connectors on a standard Cat5e or Cat6 Ethernet cable. 2. Strip off about 40 mm (1½ inch) of the cable jacket and untwist the orange, orange/white, green and green/white wires. The other wires will not be used. 3. Strip off about 7 mm (¼ inch ...

pre-configured Easy Config modes. Advanced configuration can be carried out by issuing AT (modem) commands through the web interface or over a Telnet or RAW TCP connection to port 8080. A list the of supported ATcommands is included in the we ...

The following Easy Config Modes can be set from the web interface. Mode Role Description 2 — Reset the configuration to the factory defaults 3 — Reset the IP settings to the factory defaults 4 Client Wait for discovery and configuration 5 WLAN AP Discover units in Mode 4 and configure them as WLAN or Bluetooth P ...

methods: ► Press and hold the RESET button for >10 seconds and then release it ► Execute Easy Config Mode 2 ► Click on Factory Restore on the System Settings page ► Issue the AT command AT&F and reboot Default Network Settings ...