biodex 950-387 Application/operation Manual
Text of the manual
GAIT TRAINER 2
APPLICATION/OPERATION MANUAL
950-385
950-386
950-387
950-395
950-396
950-397
950-398
BIODEX
Biodex Medical Systems, Inc.
20 Ramsay Road, Shirley, New York, 11967-4704, Tel: 800-224-6339 (In NY and Int’l, call 631-924-9000), Fax: 631-924-9338, Email: [email protected], www.biodex.com
FN: 05-159 5/05
— II —
This manual covers installation and operation procedures
for the following products:
#950-385
Gait Trainer 2, 115 VAC
#950-386
Gait Trainer 2, 230 VAC
#950-387
Gait Trainer 2, 100 VAC (Japan)
#950-395
Gait Trainer 2, 230 VAC (German)
#950-396
Gait Trainer 2, 230 VAC (Italian)
#950-397
Gait Trainer 2, 230 VAC (French)
#950-398
Gait Trainer 2, 230 V
1. INTRODUCTION ..........................................................................................................................1-1
2. CLINICAL CONSIDERATIONS FOR GENERAL USE ..........................................................2-1
3. SETUP ........................................................................................................
Designed specifically for rehabilitation and retraining of gait for patients with neurologic and
orthopedic gait dysfunctions, the Biodex Gait Trainer 2 provides both the audio and visual feed-
back needed to progress patients quickly and safely to normal ambulation.
The Gait Trainer 2 is easy to use. The clinician need only select the patient’s age and he
The following clinical considerations should be observed for all patients who exercise on the
Biodex Gait Trainer 2. Additional clinical considerations, specific to gait training, are provided in
the chapter titled: Clinical Applications and References.
1. All patients should consult a physician before beginning any rehabilitation program.
2. Instruct pati
Figure 3.1. Attaching the Safety Lanyard, printer cable and printer.
Included with the Gait Trainer 2 are a printer, printer stand and Safety Lanyard. These should all
be attached/installed prior to operation of the Gait Trainer 2.
CONNECTING THE PRINTER
(See Figure 3.1.)
The printer cable should be connected to the printer receptacle at the back of the disp
HANDRAIL INSTALLATION (OPTIONAL)
(See Figures 3.2 – 3.4.)
Figure 3.2.
Figure 3.3.
Figure 3.4. The Biodex Gait Trainer 2 comes with a sturdy support bar installed (Figure 3.2).
Optional Standard (Figure 3.3) and Geriatric/Pediatric handrails (Figure 3.4) are also available.
CONTENTS
SET-UP
— 3-2 —
The Biodex Gait Trainer 2 comes with a sturdy support bar, but optional Standard Rehab and
Geriatric/Pediatric handrails are also available. Both optional handrails are installed as follows:
NOTE: Do not fully tighten any screws until all the screws and hardware have been positioned and par-
tially secured.
1.
Using a Phillips screwdriver, remove the two scr