Bodet Profil 930 Installation And Operating Instructions Manual

Fax : +33 241 71 72 01 www.bodet-time.com Upon receipt, always check the product for damage during shipment. If any is found, you may file a damage claim with the carrier. Réf.: 605751 X Clocks Profil 930-940 Profil TGV 930-940 Profil 930 metal Independent QUARTZ on battery IRIG B/AFNOR - DHF ...

I - INITIAL VERIFICATION 3 1.1 Unpacking the clock 3 1.2 Cleaning 4 II - INSTALLATION 4 2.1 Single Face indoor clock 4 2.2 Single Face outdoor clock 4 2.3 Double Face clock 5 III - POWER SUPPLY 5 3.1 Clock with batteries 5 3.2 Clock with 230V power supply 5 DHF Slave clock (230V) : 5 AFNOR/Irig-B clock 230V : 5 3.3 AFNOR Clocks with TBT po ...

Thank you for choosing a BODET clock. This product has been carefully designed for your satisfaction based on ISO9001 quality requirements. We advise you to read this manual thoroughly before attempting to manipulate the clock. Keep this booklet during all the life of your clock, so that you can refer to it each time it will be nec ...

in 240 VAC. Nota : all these versions are not available for all Profil or TGV 930/940 models. Contact your Bodet authorised dealer. 1.2 Cleaning Use an antistatic product of similar type to the one shipped in the original packaging. Never use alcohol, acetone or any other s ...

- Fit the bracket on the wall or on the ceiling with 2 screws Ø6. - If necessary, carry out the various connections (external supply see page 5 and connection to a time distribution network : see page 7). - Present both clock on the bracket, then turns it a quarter turn in the clockwise so that the clocks are in the correct positi ...

Single Face. • Connect mains supply to the terminal (11) of the power supply unit. • Connect the telephone cable of the fake battery (13) on terminal (12) of the power supply unit. • Set the fake battery (13) in its location with care for polarities. Double Face. • Connect mains supply to the terminal (11) of the ...

When the power is back but not the Afnor signal, the hands are driven to 12h00. It is compulsary, for a correct running, to respect the following parameters. These parameters are calculated considering 8/10 mm wire section with 1A (Microquartz Delta). Number of clocks D ...

by the BT radio). - Connect the time distribution network to terminals 1 and 2 on the terminal strip (3). - The terminal 3 of the terminal strip (3) is available. You can use it to connect a double side clock following the diagram opposite. To insure the continuation of the serial distr ...

4.2.1 230V Slave clock - Connect the time signal network to terminals 1 and 2 (2). Before fixing the clock on its wall support, check that, on the PCB, the dip switch (D) is in the “Start” position. Lock the wires with collars (S). Caution : the locking must be well done to get the electrical contact. - When swit ...

- Connect the afnor line on connectors 3 and 4. The terminals 1 and 2 are reserved for power supply (see page 6). - When receiving the power, the hands are driven to 12h00 until the clock receives a radio signal. After controlling the data (3 coherent messages) the clock is automatically driven to the current time by a ...