Cisco RV110W Quick Start Manual

Cisco RV110W Wireless-N VPN Firewall Package Contents • Wireless-N VPN Firewall • Ethernet Cable • Power Adapter • Quick Start Guide • Documentation and software on CD-ROM ...

Welcome Thank you for choosing the Cisco RV110W Wireless-N VPN Firewall. The RV110W provides simple, affordable, secure business-class connectivity to the Internet for small office/home office (SoHo) and remote professionals. This guide describes how to physically install your Cisco RV110W and launch the web-based Devic ...

3 Back Panel RESET Button—The RESET button has two functions: • If the Cisco RV110W is having problems connecting to the Internet, press the RESET button for at least 3 but no more than 10 seconds with a paper clip or a pencil tip. This is similar to pressing the reset button on your PC to reboot it. Power The Power l ...

• If you are experiencing extreme problems with the Cisco RV110W and have tried all other troubleshooting measures, press and hold in the RESET button for more than 10 seconds. This reboots the unit and restores the factory defaults. Changes you have made to the Cisco RV110W settings are lost. LAN Ports (1-4)—These ...

5 STEP 3 Connect one end of a different Ethernet cable to one of the LAN (Ethernet) ports on the back of the unit. (In this example, the LAN 1 port is used.) Connect the other end to an Ethernet port on the PC that you will use to run the web-based Setup Wizard and Device Manager. STEP 4 Power on the cable or DSL modem an ...

CAUTION Use only the power adapter that is supplied with the unit. Using a different power adapter could damage the unit. STEP 6 Plug the other end of the adapter into an electrical outlet. You may need to use a specific plug (supplied) for your country. STEP 7 On the Cisco RV110W, push the POWER button in to turn on th ...

7 STEP 1 Power on the PC that you connected to the LAN1 port in Step 2 of the Connecting the Equipment section. Your PC becomes a DHCP client of the firewall and receives an IP address in the 192.168.1.xxx range. STEP 2 Start a web browser on your PC. In the Address bar, enter the default IP address of the firewall: 192.1 ...

Connecting to Your Wireless Network To connect a device (such as a PC) to your wireless network, you must configure the wireless connection on the device with the wireless security information you configured using the Device Manager. The following steps are provided as an example; you may need to configure your device d ...

9 Where to Go From Here For EU lot 26 related test result, please check this web page: www.cisco.com/go/eu-lot26-results. Support Cisco Support Community www.cisco.com/go/smallbizsupport Cisco Support and Resources www.cisco.com/go/smallbizhelp Phone Support Contacts www.cisco.com/en/US/support/ tsd_cisco_small_business _ ...