Cisco MERAKI MR72 Hardware Installation Manual

Controller are trademarks of Cisco Systems, Inc. Other brand and product names are registered trademarks or trademarks of their respective holders. Warranty Cisco Systems, Inc. provides a one year warranty on this product. Warranty details may be found at www.meraki.cisco.com/support. Tabl ...

The MR72 Hardware Installation Guide describes the installation procedure for the MR72 access point. Additional reference documents are available online at meraki.cisco.com/support 2 MR72 Overview The Meraki MR72 is an enterprise-class, 802.11abgn/ac outdoor access point designed for rugged environments. When con ...

The Meraki MR72 has two radios. Each radio has two external antenna connectors; both connectors for a particular radio should be attached to the same type of antenna. The 5 GHz radio is used for mesh or client communication. The 2.4 GHz radio is primarily used for client communication. However, it can also communicate with Meraki 2.4 G ...

Connecting Rainbow Device in process of connecting to the Meraki Dashboard Connected Solid White Fully operational Upgrading Flashing White During boot or no WAN link The MR72 may be operated in “Run Dark” mode for additional security and to reduce the visibility of the access point. In this mode, the LED will ...

new network. 3. Add your nodes to your network. You will need your Meraki order number (found on your invoice if you ordered directly from Meraki) or the serial number of each node, which looks like Qxxx-xxxx-xxxx, and is found on the bottom of the unit. 4. Finally, go to the map / floor pla ...

Controller. The most current list of outbound ports and IP addresses can be found here: http://bit.ly/oZpMQ7 3.4 Assigning IP Addresses to MR72s All gateway MR72s (MR72s with Ethernet connections to the LAN) must be assigned routable IP addresses. These IP addresses can be dynamically assigned via ...

Alternatively, browse to http://10.128.128.128. 3. Click on the “Static IP Configuration” tab. Log in. The default user name is “admin”. The default password is the AP’s serial number, with hyphens included (e.g., Q2BD-551C-ZYW3). 4. Configure the static IP address, net mask, gateway IP addre ...

gateway to the internet) - Appropriately sized metal straps (if mounting to a pole larger than 3.9” in diameter) - Specialized mounting hardware if mounting to surface other than wood, stucco or stone - Laptop with wireless to verify setup (recommended) 4 Installation Instructions 4.1 Choos ...

For most mounting scenarios, the MR72 mount plate provides a quick, simple, and flexible means of mounting your device. The installation should be done in two steps. First, install the mount plate to your selected location. Then attach the MR72 to the mount plate. 4.2.1 Remove the Mount Plate from the Access Point Before installing the m ...