CommScope Quareo 4000 Installation Instructions Manual

Page 1 www.commscope.com © 2016 CommScope. All Rights Reserved. Installation Instructions INTRODUCTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...

Page 2 © 2016 CommScope. All Rights Reserved. INTRODUCTION The Network Chassis is available as a 2-blade 1RU, 4-blade 2RU, and 8-blade 4RU. The network chassis may be operated as passive chassis, or may become part of a Managed System by inserting controllers, a network chassis display board, and connecting the Ethernet ...

Page 3 © 2016 CommScope. All Rights Reserved. 1 SPECIFICATIONS Specifications for the chassis are listed in Table 1. 2 UNPACKING AND INSPECTION Unpack and inspect the various components as follows: 1. Inspect the exterior of the shipping container(s) for evidence of rough handling that may have damaged the components in ...

Page 4 © 2016 CommScope. All Rights Reserved. 3. If damage is found or parts are missing, file a claim with the commercial carrier and notify CommScope Customer Service. Save the damaged cartons for inspection by the carrier. 4. Refer to Section 4 Technical Assistance if you need to contact CommScope. 5. Save all shippi ...

Page 5 © 2016 CommScope. All Rights Reserved. • Locate mounting hardware required. 2. Determine what rack size is being used. When installing in a 19-inch rack use the hardware provided to attach the chassis to the rack. 3. Locate the equipment rack mounting space that is specified for the chassis. 4. Place chassis in ...

Page 6 © 2016 CommScope. All Rights Reserved. 3.2 Quareo Cross-Connect Solution Installation In the Quareo cross-connect solution frame there are eight spaces for mounting network chassis. Consider them to be numbered one through eight starting at the top, see Figure 2. Figure 2. Quareo Cross-Connect Solution Frame FRON ...

Page 7 © 2016 CommScope. All Rights Reserved. When installing Quareo Network Chassis in the odd spaces (1, 3, 5, 7) the first chassis in each space is secured using the top mounting hole in the chassis and the lowest hole in chassis. When installing Quareo Network Chassis in the even spaces (2, 4, 6, 8) the first chassi ...

Page 8 © 2016 CommScope. All Rights Reserved. Figure 4. 2RU Chassis Ground Location 4. Connect the other end of the ground wire to the earth ground conductor. Ensure this connection is made using methods and hardware that meets all applicable local and national electrical codes. 3.4 Power Cabling Each chassis controller ...

Page 9 © 2016 CommScope. All Rights Reserved. transition from PoE to AUX is seamless. If AUX power is discontinued there is an interruption of power and communications to the controller before power is supplied by the PoE switch. 3.4.1 AUX Power Refer to Chassis Controller Installation Instructions (ADCP-92-311) for AUX ...

Page 10 © 2016 CommScope. All Rights Reserved. When the blade is fully pushed into the chassis it is connected to the back plane. The blade remains connected to the back plane at the first detente position. When the blade is pulled out to the second detent the blade is disconnected from the back plane. When the blade is ...