Control 4 AVM-MC1-B Installation And User Manual

tray, remove the CD, and close the CD tray. Choose a Playlist Option 1. On the Media Controller front panel, open the CD tray (press the EJECT button), load a CD, and close the CD tray. The LCD should now display the CD menu. 2. Using the dial, choose Playlist (turn the dial to highlight Playlist, then press the dial). The Playlist options display: Create a new playlist Load a CD to a new or existing playlist Select a playlist to be played 3. To create a new playlist: 3a. Choose Create a new playlist and then follow the screen prompts. 3 ...

navigation device. For detailed information on the remote control, refer to the System Remote Control User Guide included with your Control4 remote control. Media Controller Front Display The information that displays on the Media Controller front display depends on the action you choose with the Media Controller buttons or with some other system navigation device. ----------------------------------------------------- ..............Control4.................. ...Saturday, Nov. 13 .....00:06:30... .............................................. ...

Controller This chapter introduces a Control4 home system and explains the important role a Media Controller plays in that system. Role in a Control4 System Control4 systems are uniquely configured for every customer and every site. Your system may be simple or complex, depending on what you want the system to control. An essential component in every Control4 home system is a controller, such as Media Controller, that acts as the brain of the system. In addition to providing control options, Control4 controllers are designed to meet specific home system ...

IR sticky emitters that can be placed over IR readers on media players, TVs, or other targets to transmit infrared control signals from Media Controller to the target . 1. 2. 3. 4. 5. 6. 7. 8. Video Sense Loop— Composite port In-Out pairs for up to 4 video sources, such as DVD players or VCRs, that allow the system to detect the On/Off status of devices that use the same IR code for both On and Off commands. 1. 2. 3. 4. Ethernet—RJ-45 for a 10/100 Baset Ethernet connection. 1. USB—Two USB ports for card readers or other USB devices. 1. 2. Modem—RJ-1 ...

In a Media Controller system, physical and logical connections are required in order to control, navigate, and use the system as designed. This section describes, in general terms, how to set up the physical connections required for Media Controller and all of the devices associated with it. You should also refer to any device-specific documentation for additional installation instructions. To set up the logical connections required, refer to Control4 Composer User Guide software documentation. Home Network Requirements Ensure that your home network wiring i ...

1. Insert one of the wires required for your device into the appropriate opening in the Plugable Terminal Block you reserved for that device (refer to Table 2-2 on page 17). For example, if you were adding an IR motion sensor, you would connect the motion sensor power input to +12v, its ground connector GND, and its output to SIG. 2. Lower the opening’s latch until it locks the wire in place. 3. Repeat Steps 1-2 for all wires required for your device. Connect Wires to a Configurable Serial Port Media Controller provides four serial ports: ...

Controller This chapter introduces a Control4 home system and explains the important role a Media Controller plays in that system. Role in a Control4 System Control4 systems are uniquely configured for every customer and every site. Your system may be simple or complex, depending on what you want the system to control. An essential component in every Control4 home system is a controller, such as Media Controller, that acts as the brain of the system. In addition to providing control options, Control4 controllers are designed to meet specific home system ...