Digisol DG-BA3370 Quick Installation Manual
Text of the manual
Copyright © 2012. All rights reserved.
Company has an on-going policy of upgrading its products and it may
be possible that information in this document is not up-to-date.
Please check with your local distributors for the latest information.
No part of this document can be copied or reproduced in any form
without written consent from the company.
Trademarks
Supports HSPA / UMTS (2100MHz), GSM / GPRS / EDGE
(850/900/1800/1900MHz)
Support HSDPA (7.2 Mbps), HSUPA (5.76 Mbps), UMTS (384 Kbps), EDGE
(237 Kbps), GPRS (85.6 Kbps).
Support SMS, phone book, Volume Statistics via Software.
USB 2.0 High speed interface.
Micro SD slot for Mass Storage, maximum capacity up to 32GB.
No-CDROM required, auto i
Below shown is the front and rear view of the 3G USB adapter
The above figure shows the appearance of the 3G USB adapter. It is
provided only for reference and the actual product image may vary.
Sr. No.
Interface
Description
1
USB Connector
It connects to the USB port of the notebook/desktop computer
2
LED Indicator
It indicates the status of th
Following are the steps for inserting the SIM and a Micro SD card in the
3G USB adapter.
Slide the back cover to remove it from the 3G USB adapter.
1
2
3
Insert the SIM card into its corresponding slot, as shown in the
following figure.
Insert the Micro SD card into its corresponding slot, as shown in the
following figure.
Ensure that t
Plug the 3G USB adapter into the USB port of your PC.
1
2
Software Installation
Replace the back cover and slide it into place
4
Note: Do not remove the Micro SD or SIM card when the card is in
use. Otherwise, the card as well as your 3G USB adapter may get
damaged and the data stored on the card may get corrupted.
The software installation procedure depends
The OS automatically detects and recognizes the new hardware and
starts the installation wizard. Click ‘Next’ button to continue with
the installation.
Note: If installation does not start automatically then go to my
computer and click on the CD ROM ICON “3G - Connect”
2
Select the drive and folder for installing the software, and then click
the 'Nex
Select start menu folder and additional tasks, and then click the
‘Next’ button to continue with the installation.
4
If you wish to create the icon on the desktop then select the
checkbox else unselect it. Click the ‘Next’ button to continue with
the installation.
5