DSC neo HS2032 Installation Manual

zone expanders, keypads and other required modules. 2 Mount Decide on a location for the alarm panel and secure it to the wall using suitable mounting hardware. 3 Wire Complete all wiring including modules, zones, bells/sirens, telephone line connections and ground connections. R ...

Safety Instructions for Service Personnel Warning: When using equipment connected to the telephone network, always follow the basic safety instructions provided with this product. Save these instructions for future reference. Inform the end-user of the safety precautions that must be observed when operating this equipment. ...

l The modules can be home run to the panel, connected in series or can be T-tapped. l Do not use shielded wire for Corbus wiring. Note: Any module can be connected anywhere along the Corbus. Separate wire runs for keypads, zone expanders etc. are not necessary. Note: No module can be more than 1,000'/305m (in wire length) f ...

Capacitance Limits An increase in capacitance on the Corbus affects data transmission and causes the system to slow down. Capacitance increases for every foot of wire added to the Corbus. The capacitance rating of the wire used will determine the maximum length of the Corbus. Table 1-3 Wire Capacitance Wire Capacitance per ...

Double End of Line (DEOL) Resistors When double end-of-line (DEOL) resistors are installed at the end of a zone loop, the second resistor enables the panel to determine if the zone is in open, closed, tampered or faulted. Note: Any zone programmed for Fire or 24-hr Supervisory must be wired with a SEOL resistor regardless o ...

To confirm that a module has been successfully enrolled, use Installer Programming section [903]. Enroll Wireless Devices Wireless devices are enrolled via the wireless transceiver module and Installer Programming section [804][000]. Auto Enrollment To enroll a wireless device using this method, press and hold the Enroll bu ...

placed in common areas of the premises, such as points of entry or reception areas, where the ability to arm and disarm more than one partition at a time is required. Partition keypads can also be temporarily loaned to other partitions. To select a keypad operating mode: 1. Enter Installer Programming: [*][8][installer code ...

After 15 minutes without zone activity, the walk test terminates automatically. To manually exit walk test mode, enter [901] again. Viewing the Event Buffer The event buffer contains logs of events that have occurred on the alarm system beginning with the most recent. The capacity of the event buffer is scalable and can hol ...

Trouble 07 – Device Tampers: [01] Zone 001 - 128 Tamper: A wireless or hardwired zone configured for DEOL operation is in tamper. [02] Keypad 01 - 16 Tamper: A hardwired or wireless keypad is in tamper. [03] Siren 01 - 16 Tamper: A wireless siren is in tamper. [04] Repeater 01 - 08 Tamper: A wireless repeater is in tamper ...

Access Codes l Up to 1002 access codes: 1000 (level 2-EN), one installer code (level 3-EN), and one maintenance code l Programmable attributes for each user code l When using 8-digit access codes, the minimum number of vari- ations are: HS2016: 2083333 HS2032: 1388888 HS2064/HS2128: 1052631 HS2064 E: 200000 HS2128 E: 100000 ...