EPOS FlashExtractor Operation & User’s Manual

www.epos.ua April 2011 Ver. 1.0 Sales and support EPOS Data Recovery Center 34, Verkhniy Val str., Kiev, 04071, Ukraine www.epos.ua/recovery Tel.: +380 (44) 467-7540 Fax: +380 (44) 467-7547 e-mail: [email protected] © 2011. EPOS LLC. ...

1.1. Overview ........................................................................................................................................ 3 1.2. What in the box................. ...

FlashExtractor is a professional tool for reading NAND flash memory chips. EPOS FlashExtractor 1.2. Package contents Your EPOS FlashExtractor comes in a complete kit which includes cables, adapters, and a power supply. Inside the box, you will find the following ...

This guide is divided into four main sections: Introduction Installation Quick start guide Operation Please read Installation and Quick Start Setup sections before attempting a flash memory chip reading. It is recommended that you practice with a scratch chip to fully appreciate the procedures. The FlashExtractor User’s Guide wi ...

The following picture illustrates the location of controls on the FlashExtractor. a) e-SATA Port. b) 3-Color Mode Led. GREEN. Unit is powered on, connected to PC and ready to operate. YELLOW. Memory chip reading is in progress. RED. Unit is not connected to PC or not-supported data transfer mode (other than ...

EPOS FlashExtractor require certain hardware and software specifications in order to operate. The following list of requirements applies to the current version of EPOS FlashExtractor. These are basic requirements, though you may want to use our recommended suggestions to improve performance. Software Microsoft Windows XP, Microsof ...

EPOS FlashExtractor and its software (FlashReader application) does not require installation and installation of the additional drivers. After connecting to e-SATA port of PC and starting FlashReader application the unit is ready to operate. It is possible to use up to 4 units simultaneously per one PC. Hardware inst ...

turn off the PC before connecting unit to these ports. Some SATA ports may assign PIO transfer mode for hot-plugged device that is not supported by FlashExtractor. If unit is detected in PIO mode Mode Led lights red. FlashExtractor won’t operate in this mode. Operating system sto ...

on, the update will be impossible. 3. Connect the USB Update Adapter to the device and then connect it to a PC via USB cable; 4. Turn the device on and wait for the diagnostic message "Devices setup completed" (Установка устройств завершена). The device in ...