Happy HCS Instruction Book

WARNING MARKS, LABELS, MEANINGS AND LOCATION .. 1-2 SETTING UP THE MACHINE Remove the machine from box .............................2-1 Accessories...........................................................2-2 Assemble machine kit ...........................................2-3 Machine installation ........ ...

1_1 F201 1-1 When using an electrical appliance, basic safety precautions should always be followed, includ- ing the following. Read all instructions before using this appliance. DANGER - To reduce the risk of electric shock: 1. An appliance should never be left unattended when plugged in. Always unplug this applianc ...

1_2 K101 1-2 Trapping hazard Shut the cover when starting the machine. Do not put hands in while the machine is running. Trapping, Puncture, Cut hazard wherever this label is found Power Supply Voltage sticker Risk of electrical shock and fire if the power recommendations on this label are ignored! Make sure that ...

2_1 K101 2-1 CAUTION: To prevent accidents. The machine is quite heavy for one person to carry. Please use two persons when unpacking or carrying. CAUTION: To avoid problems. Make sure to hold bottom of the machine body when removing from the box. Do not hold any other place. (bed, moving head, control box etc.). We recom ...

2_1b K101 2-1b Placement of Accessories Confirm all the accessories are contained when unpacking. Frame base CD-ROM (Instruction manual, Parts list) CD-ROM (HAPPY Link Software) Instruction manual Embroidery sample Embroidery frame (Round) Embroidery frame (Square) Thread stand Thread guide bracket Carriage Thread stand fel ...

Accessories Please confirm you have received the following. 2_2 K101 2-2 1. Thread guide bracket 2. Thread guide pillar (2 pcs) 3. Thread stand 4. Thread stand felt (13 pcs) 5. Thread stand pin (13 pcs) 6. Wave washer (13 pcs) 7. Carriage 8. Frame base 9. Embroidery frame (square) PTA-32320-360 10. Embroidery frame (Round) ...

1. Insert the thread stand pin with wave washer on the thread stand by turning clockwise, Then insert thread stand felt. 2. Put the thread stand on to the machine and insert the thread guide pillar. (set nut knob nut into the thread guide pillar and 2 washers) Turn the thread guide pillar clockwise with a 3 mm hexa ...

on. Please check for any shaking or excessive vibrat- ing of the machine table when the machine is running. If you have a problem, Please use a stronger table for the machine. 2_4 D607 2-4 SETTING UP THE MACHINE 350 mm 350 mm 720 mm 2. Please sit the machine level on the table. 3 ...