Kikusui PAS 10-35 Operation & User’s Manual

Jan. 2017 USER’S MANUAL Regulated DC Power Supply PAS Series PAS 10-35 PAS 20-18 PAS 40-9 PAS 60-6 PAS 80 -4.5 PAS 160-2 PAS 320-1 PAS 500-0.6 PAS 10-70 PAS 20-36 PAS 40-18 PAS 60-12 PAS 80 -9 PAS 160-4 PAS 320-2 PAS 500-1.2 PAS 10-105 PAS 20-54 PAS 40-27 PAS 60-18 PAS 80 -13.5 PAS 160-6 PAS 320-3 PAS 500-1.8 350W Type 700W Type 100 ...

These manuals are intended for users of the Regulated DC Power Supply and their instructors. It is assumed that the reader has knowledge about electrical aspects of regulated DC power supplies. Documentation Structure User’s manual (This manual, PDF) This manual is intended for first-time users of this product. It provides an ove ...

following symbols are used throughout this manual and on the product. Understand the meanings of the symbols and observe the instructions they indicate (the choice of symbols used depends on the products). Indicates that a high voltage (over 1,000 V) is us ...

fire hazard, electrical shock, accidents, and other failures. Keep them in mind and make sure that all of them are observed properly. Using the product in a manner that is not specified in this manual may impair the protection functions provided b ...

Cover • There are parts inside the product which may cause physical hazards. Do not remove the external cover. Installation • When installing products be sure to observe "1.2 Precautions for installation" described in this manual. • To avoid electrical shock, connect the protective ground terminal to electrical ground ...

PAS SERIES Operation • Check that the AC input voltage setting and the fuse rating are satisfied and that there is no abnormality on the surface of the AC power cord. Be sure to unplug the AC power cord or stop applying power before checking. • If any abnormality or failure is detected in the products, stop using it immediately. Un ...

Safety Precautions - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - II Preface About this manual - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - P-1 Outline of the PAS series- - - - - - ...

4.1.1 About the J1 Connector - - - - - - - - - - - - - - - - - - - - - - - - - - - -4-2 4.1.2 Controlling the Output Voltage Using External Voltage - - - - - -4-5 4.1.3 Controlling the Output Voltage Using External Resistance- - ...

7.3.3 Calibration Mode - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 7-10 7.3.4 Calibration Procedure - - - - - - - - - - - - - - - - - - - - - - - - - - - - 7-11 7.4 Malfunctions and Causes- - - - - - - - - - - - - - - - - - - - - - ...