Lippert Components 432223 Installation Manual

System Information Safety Information TABLE OF CONTENTS System Information 2 Safety Information 2 Resources Required 3 Preparation 3 Under Bumper Attachment 3 Over Bumper Attachment 3 Installation 3 Under Bumper Attachment Assembly 3 Over Bumper Attachment Assembly 6 Bike Rack Accessories 8 Spar ...

Preparation Under Bumper Attachment NOTe: If using the under-mount attachment (Fig. 1) assembly (432223) to connect the bike rack, verify that the chassis was equipped with the necessary assembly bracket mount. Over Bumper Attachment NOTe: If using the over-mount attachment (Fig. 2) assembly (43 ...

Fig. 4 1. Locate the following on the trailer: the frame rails (Fig. 4A), the bumper bracket (Fig. 4B) and the bumper (Fig. 4C). 4" A B C Fig. 6 A A B A B C Fig. 5 2. Bolt on the weld-on brackets (Fig. 5A) to the bike rack support arm (Fig. 5B), using 4 supplied 3/8”-16 x 1 1/2” zinc bolts ...

Fig. 7 Fig. 8 7. Lift the bike rack support arm, with weld-on brackets attached, and center the assembly on the frame rails. 8. While supporting the bike rack support arm, outline the weld-on bracket placement onto the frame rail with a marker. NOTe: A minimum of 4" is needed for the bike rack ...

Over Bumper Attachment Assembly NOTe: Verify that trailer is not equipped with the weld-on brackets (Fig. 3). The trailer MUST NOT have these brackets in order to complete the installation of the over bumper bike rack brackets. If the brackets are present, either grind off the weld-on brackets o ...

Fig. 12 Fig. 13 7. Repeat step 1-6 with the remaining curbside bike rack bracket. 8. Once the bike rack bracket is secured onto the chassis frame rails, the Light Bolt-on Bike Rack can be attached to the bike rack bracket assembly. 9. Lift the bike rack up so that it is perpendicular (Fig. 12A ...

Bike Rack Accessories Spare Tire Carrier 1. Place the tire, hub side up, directly underneath the spare tire bracket (Fig. 14). 2. Insert one bolt from inside of the spare tire carrier down through the tire carrier and exiting through one of the wheel stud holes. 3. Thread and secure a nyloc nut ...

Optional Vertical Bike Support Bracket 1. Remove the snapper pin (Fig. 15A) from the mounting tube (Fig. 15B). 2. Rotate the mounting tube vertically (Fig. 16A) and place it in the mounting bracket (Fig. 16B). Fig. 15 Fig. 16 Fig. 17 3. Insert the snapper pin completely through the mounting b ...

LCI prohibits the copying or dissemination of portions of this manual unless prior written consent from an authorized LCI representative has been provided.  Any unauthorized use shall void any applicable warranty. The information contained in this ma ...