Lister A 1600-3 Operating Instruction

Release: 10 / 2012 (09932103330) OPERATING INSTRUCTION ANIMAL CLIPPER - with rechargeable Battery-Pack Equi Akku Perfekt Perfekt Perfekt Perfekt TYP A 1600-3 ...

1 Safety Instruction ................................................................................. Page 3 - 6 1.1 General information 1.2 Symbols and warning indications 1.3 Correct use 1.4 Safety basics 1.4.1 Safety regulations 1.4.2 Precautions for the charger station 1.4.3 Precautions for the battery-pack 1.4.4 General safety ...

operation and maintenance. All persons operating or working with the clipping machine must read these operating instructions most carefully. The operating instructions should always be available at the place where the applian ...

about safety and handling of the animal clipper and the charger station. The incorrect usage of the charger station and the animal clipper may be hazardous! Please observe the following measures for accident protection before putting the appliance into o ...

battery-pack by any other means. 1.4.4 General safety measures 1. Use the animal clipper with rechargeable battery-pack only for the purpose described in the instructions for use. 2. Never try to clip wet animals. 3. Make sure that children have never access to areas where trimming ...

these are compulsory to be followed and observed: • The operator has read and understood this operating instruction, or has been instructed by an expert on the use and operation of the clipping machine and the dangers. • The operator is e ...

1 set of clipper blades (mounted) 1 Battery-Pack (mounted) 1 Battery-Charger 1 spanner - with 4 mm 1 bottle of special-oil 1 operating instruction 1 case for transport and storing Options: Various different clipper blades 3 PUTTING INTO OPERATION 3.1 Charging the Battery-Pack Your new battery-pack ...

charger does not necessarily light up. If this happens first let the battery-pack cool down and then start charging. If the control light still does not light up there might be a foreign body in the battery compartment which has to be removed. If this is not the case you ...

Lack of lubrication is the most common cause of unsatisfactory clipping results and overheating of the clipping machine. For best clipping results as well as for enhancing life time of the clipping blades and the machine, apply a thin oil film on the blades. Other moving parts of the clipping head should al ...

Adjust the clipper blades as follows: When machine is switched off: Please make sure that the taper pins of the carrier fit into the holes of the upper blade (picture 4). Unscrew the counter nut anti-clockwise and tighten the adjusting screw clockwise until the first sensible resistance. Now start up the a ...