McAfee NS7200 Quick Start Manual

® Network Security Platform NS7100, NS7200, and NS7300 Sensors in in-line mode. These models have a throughput of 1.5 Gbps, 3 Gpbs, and 5 Gbps respectively. All product documentation referenced in this quick start guide is found on the McAfee ServicePortal. The NS7100/NS7200/NS73 ...

Figure 2 Sensor rear panel 1 Auxiliary port (1) 2 USB ports (2) 3 Power supply inlet (2) The NS7x00 Sensors are shipped with one power supply unit. Second power supply (optional) is supported to enable redundancy. 4 RJ-45 10/100/1000 Response port (R1) (1) 5 RJ-45 ...

• Windows Server 2008 R2 Standard or Enterprise Edition, SP1 (Full Installation), English operating system • Windows Server 2008 R2 Standard or Enterprise Edition, SP1 (Full Installation), Japanese operating system • Windows Server 2012 Standard Edition (Ser ...

1.5 GHz or faster Browser • Microsoft Internet Explorer 9, 10, or 11 • Mozilla Firefox • Google Chrome (App mode in Windows 8 is not supported.) If you are using Google Chrome, add the Manager certificate to the trusted certificate list. • Internet Explorer 11 • Mozilla Firefox 20.0 or later • Google Chro ...

a Place each inner member on both sides of the chassis unit. Position the bottom mounting holes of the inner member with matching mounting holes on chassis unit. b Use screws to secure inner members in place. Apply to both sides of chassis unit. c Mount the slide cabinet sections to the rack. a Install the front ...

a Guide the chassis unit into the pre-installed cabinet sections. Allow the pre-installed inner members to slide into the outer members until they lock in place. b Depress the QD latch on both sides and continue to push the chassis unit in until fully closed. e Secure the chassis unit through the ra ...

• 4-port 10/1 GigE MM 62.5 micron with internal fail-open interface module a Remove the module from its protective packaging. b Hold the module using your thumb and forefinger and insert it into the modular bay. c Drive in the screws fixed on the sides of the module to attach it to ...

Console). d Connect the other end of the Console port cable directly to a COM port of the PC or terminal server you are using to configure the Sensor (for example, a PC running correctly configured Windows Hyperterminal software). You must directly connect ...

This procedure describes how to connect cables to a Sensor that runs in in-line mode. a Plug the cable appropriate for use with your transceiver module into one of the monitoring ports labeled x (for example, 1). b Plug the cable appropriate for use with your transceiver module into one of the monitoring ports labeled y (for ex ...

The Manager displays the Logon page. a Log on to the Manager using the default user name (admin) and password (admin123). b Click Devices. c To add a Sensor in the Manager, click Global | Add and Remove Devices, then click New. You do not require a license file to enable IPS on NS-series Sensors. The Add New Device page is dis ...