MicroNet SP5018B Operation & User’s Manual

1-1 Physical Interface ............................................................................. 4 1-2 Feature .............................................................................................. 4 1-3 Front Panel: LED Indicat ...

6 Dialing Plan ....................................................................................... 38 6-1 General ............................................................................................ 38 6-2 Dialing Rule .................. ...

Micronet SP5018B are high-capacity SIP Gateway Series that provides 4 FXS + 4 FXO ports, and suit to build an IPbased communication platform with other VoIP devices. They meet enterprise's requirement for VoIP functionality upgrade and larger scale implementation by interoperating with legacy PABX and IP PBX/Soft-s ...

ports Support up-to 16 SIP trunk to register Support extension calling among FXS ports Support rich call features: call hold, call transfer, call forward, hotline, speed dial, anonymous call, P2P call, etc Support flexible Dial plan and route plan features Support IPv6 only, IPv ...

LED Description PWR When the power adapter is connected, the LED will light up green. PROXY When the gateway is registered successfully to SIP Proxy or IP-PBX, this LED will light up green. WAN This LED will light up green when the gateway’s WAN port is physically connected to IP Ethernet. When data is transmitted through ...

These 1 – 4 of RJ-11 connectors are used to connect with local PSTN line or analog extension of conventional PBX. The RJ-11 connector color should be Gray. Only install FXO module from port 1. DO NOT install FXO module position behind FXS module. 5 – 8 These 5 – 8 of RJ-11 connectors are used to connect with analog telephone ...

Step 2: After login, the screen shows the Home page of SP5018B. (See figure 1-5-2 Network configure-1) Figure 1-5-2 Network configure-1 Change Default IP Network: Step 3: After successfully login to the system, we need to change the network configuration. Click Device Setting > Network to set up the service networ ...

need to change the LAN port to other segment such as 192.168.x.x in order not to conflict IP between WAN and LAN. Figure 1-5-3 Network configure-2 Change Default Time setting: Step 4: When re-login to the new IP address, the next is to setup the system time zone. Click ...

Step 5: The next step is to add a SIP Trunk for VOIP calling. For SP5018B, it is necessary for VOIP calling. Click SIP Trunk and new to create the required SIP trunk. Enter the trunk ID to 1 and enter those SIP parameters. Apply the change by clicking Apply button. (See Figure 1-5-5 SIP Trunk) Figure 1-5-5 SIP Trunk Note: Ple ...