Aeotec ZW062 Manual 

Text of the manual

View the expanded manual:

http://aeotec.com/support GEN5 Garage Door Controller Aeotec by Aeon Labs Garage Door Controller. Aeon Labs Garage Door Controller is a smart and wireless Garage Door Control system, you can control the garage door to open, close, or stop moving via wireless signal on your gateway client or phone application. You can also control it

If you are using double-sided tape, wipe the two surfaces clean of any oil or dust with a damp towel. When the surface

has completely dried, peel one side of the tape back and attach it to the corresponding section on the rear side of the mounting plate. You can choose each of way from these 2 installations above. Just need to note if the environment tempera

Aeon Labs Garage Door Controller Gen5

Engineering Specifications and Advanced Functions for Developers Aeon Labs Garage Door Controller is a smart and wireless Garage Door Control system, you can control the garage door to open, close, or stop moving via wireless signal on your gateway client or phone application. The Garage Door Controller allows you to c

2. Technical Specifications

Operating Distance: Up to 980 feet/300 metres outdoors. 3. Familiarize Yourself with Your Garage Door Controller 3.1 Interface 4. All functions of each trigger 4.1 Function

Press and hold

20 seconds and released Reset Garage Door Controller to Factory Default: 1. Make sure the Garage Door Controller is connected to the power supply. 2. If holding time more than one second, the Network LED will fast blink. If holding time more than 20seconds, Network LED will be on for 2 seconds, which indicates the reset operation is successf

Forward the Basic Set, Switch Binary Set commands to associated

nodes in Group 2 when the Garage Door Controller receives the Basic Set, Switch Binary Set commands from main controller. 6.2 Association Group Info Command Class 6.2.1 Association Group Info Report Command Class Profile: General: NA (Profile MSB=0, Profile LSB=0) 6.2.2

1, Value1: configure the frequency of blinking for the Alarm

LED, there are 10 levels that 1 to10 level, the minimum frequency is level 1 and the max frequency is level 10. 2, Value2: configure the alarm sound (there are 4 types sound saved in EEPROM and user also can update it). 3, Value3: configure the volume of alarm sound (there are 10 levels, the min

2. You can send the value=0x55555555 of this parameter to

controller to relieve the alarm state. 0x2A(42) Configuration report for the battery state of Sensor: 1, Value=0x00: battery power is much more. 2, Value=0x0F: battery power of Sensor is in low battery. It will report the battery power state to associated nodes automatically when the battery power i

then exit the pairing status automatically.

2. The Sensor has been paired with the Garage Door Controller after factory. 0xFC(252) Enable/disable configuration locked 1, Value=0:Enable. 2, Value=1:Disable. 0 1 0xFF(255) 1.Value=0x55555555、Default=1、Size=4 Reset to factory default setting and removed from the z-wave network 0 4 2.Reset to factory de

Other Garage Door Opener Manuals