Antari M-1 Operation & User’s Manual

Congratulations on the purchase of your new ANTARI M-1 Mobile Fog Machine ‹ Save and read these instructions ‹ Bitte lesen Sie und sichern Sie diese Anweisungen ‹ Lisez et Gardez ces instructions ‹ © 2007 Antari Lighting and Effects Ltd. ...

Introduction Thank you for choosing Antari’s M-1 Mobile Fogger. You now own a sturdy and portable state-of-the-art fog machine. Prior to use, we suggest that you carefully read all of the instructions. By following the suggestions found in this user manual, you can look forward to exceptional performance from your Antari Mobile Fog Machine for years to come. Please follow these operations, safety and maintenance instructions to ensure a long and safe life for your fog machine. Specifications ƒ Fog Output: 300 cubic feet / per minute ƒ Power Consumption: 75W ƒ Fluid Tank Capacity: 110 c.c. ƒ Battery: DC12V / 2.3Ah ƒ Fluid C ...

ƒ Fog machine output is hot. Avoid coming within 50 cm of the output nozzle during operation. ƒ Place the fog machine in a well-ventilated area. Never cover the vents on the front of the M-1. Never aim the output nozzle at open flames. ƒ The output nozzle becomes hot during operation. Keep flammable materials at least 50 cm away from the nozzle. ƒ Always allow your Antari Fog Machine to cool down before attempting to clean or service it. Danger of Explosion ƒ Do not expose the battery to excessive heat, keep away from open flames and do not attempt to remove the case. ƒ Never add flammable ...

especially in the nozzle area. ƒ Fill with Antari Fog Liquid (FLM-05) or dealer recommended high-quality water-based fog fluid. Any other types of fluid can damage the unit. When filled, place cap back on liquid tank. ƒ Charge the battery. Plug the adaptor into a grounded electrical outlet. The green light on the battery charger will light up when it is connected to the power supply. Then connect the charging head to the battery. Please note the battery required 8hr charging time on first charge. The battery will be fully charged in ...

tank). ƒ To select operation mode 2. Slide the switch towards the front of the M-1 (towards the nozzle). ƒ When an optional remote is connected, please see the detailed instructions for their operation below. ƒ The machine will fo until the battery charge runs down or the M-1 runs out of fog liquid. When the M-1 is connected to the optional power adaptor, carefully monitor the level of the fog liquid to make sure the machine does not run out of liquid. Operating continuously, the machine will run out of liquid in approximately 50 minutes. � ...

Users can purchase the optional dummy battery and power adaptor for M1. (Item Number: DCP-12) The power adaptor can be used at AC100~240V power outlets. It can transform AC power into DC12V and power the M-1 by the dummy battery. Although the mobility of using dummy battery and power adaptor set is not as good as the use of battery due to the limitation of power outlet and cord, it can satisfy the requirement of longer operation time and users do not have to worry power exhaustion problem. ƒ If you experience low output, pump noise or no output at all, remove the battery immediately. Check fluid level an ...

感謝您選用Antari 煙霧機產品，現在您已經擁有高科技的專業煙霧機，在開始使用之前，我們建議您 先仔細閱讀本說明書，遵循使用手冊中的說明，這會有助於您在使用Antari 煙霧機時得心應手，達到 最滿意的煙霧效果，對於機器的使用壽命也更為延長。 ፟ጡఢॾ! ƒ 煙霧輸出速率: 300 立方英呎/每分鐘 ƒ 功率: 75 瓦特 ƒ 油桶容量: 110 c.c. ƒ 電池規格: 直流12V /2.3Ah ƒ 耗油速率: 2c.c./每分鐘 ƒ 適用煙霧水: Antari FLM-05 煙霧水 ƒ 選� ...

ƒ 清潔、從事維護及收納機器時，請先確認機器已經完全冷卻。 ᔖҺᘕࠓ۞щБֹϡ� ...

ƒ 電池充電方式。請將充電器接上電源插頭，在接上電源時電池上的綠燈會亮者，然後將電 池連接充電。請注意首次使用電池必須充滿八個小時，往後充電時間大約2~3 個小時。 ƒ 充完電後約能連續使用10~12 分鐘。 ƒ 電池安裝至機器時，請注意方向(貼紙面朝上-如圖示)。 放置電池時請稍微傾斜機器，會更容易置入，銀色卡榫為固定電池之用。 請確認電池放置時的位置正確(如附圖)。 ƒ 當第一次按下按鈕時，機器把手前方的綠燈會閃爍，表� ...

煙霧輸出為10 秒，而每次煙霧的輸出間距可透過控制器上的旋鈕來設定於3 至220 秒之間。 2. MCR-1 無線控制器組:將無線控制器組的訊號接收器安裝上M1，可利用發射器來控制噴煙 動作，發射訊號的有效距離在空曠處最遠可達50 公尺。 選配的假電池及電源變壓器組 您可以選購M-1 假電池和電源變壓器組(品號DCP-12) 電源變壓器組適用於交流100~240V 的電源，可轉換為直流12V 的電壓並透� ...

11 ƒ 機器不使用需收納之前請先清潔機器並確定將油桶清空，拆下控制器與電源線收好，整套 機器與配件請存放於乾燥陰涼處，每月固定溫機一次，可保護機器較不受潮。 ...