Antec P180 Operation & User’s Manual

Text of Antec P180 Operation & User’s Manual

Manuel de l’utilisateur

Anwenderhandbuch Manuale per l’operatore Manual del usuario পᡅ䂀ᯢ᳌

At Antec, we continually refine and improve our products to ensure the highest

quality. So it’s possible that your new case may differ slightly from the descrip- tions in this manual. This isn’t a problem; it’s simply an improvement. As of the date of publication, all features, descriptions, and illustrations in this manual are correct. P180 User’s Manual The P180 comes without a power supply. Make sure you choose a power supply that is compatib

6. Place your motherboard on the brass standoffs.

7. Screw in your motherboard to the standoffs with the provided Philips-head screws. Your motherboard is now installed. Front Bezel Connectors 1. Connect the Reset switch (labeled RESET SW) to your motherboard at the RST connector. The white wire for each connector should be on the ground pin. 2. Power LED (labeled POWER LED) connector is located behind the Reset connector. 3. Power Switch (labeled POWER

Note: Please check your motherboard manual for your IEEE 1394 header pin layout

and make sure it matches the attached table. If you intend to connect the front FireWire port to an IEEE 1394 add-on card that comes with an external-type IEEE 1394 connector, please call Antec customer service at (800) 22ANTEC (North America) or +31 (0) 10 462-2060 (Europe) to purchase an adapter. This adapter will allow you to connect the front IEEE 1394 port to the externa

3. There are two HDD trays inside the cage. Squeeze the metal clips on each side

of a tray and slide it out. 4. Mount your hard drive to the drive tray with the special screws provided. Don’t over-tighten the screws since that could decrease the grommets’ ability to absorb vibration and noise. Note: Always mount the hard drive with the thicker side of the silicone grommets contacting the hard drive. 5. Slide and lock the tray back into the case. 6.

5. Please refer to the power supply installation section, to route the power cables

to your devices. Once you’ve done so, connect the appropriate power connec- tors to your device. Installing the power supply 1. With the case upright and both side panels removed (see Setting Up), remove the screws on both sides of the power supply retaining cage and pull the cage out. 2. Slide your power supply into the cage, and slide the cage with power supply back i

These two fans are mounted so that the air is blowing out of the case. The top fan

comes with a spoiler to mount on the top of the case. To install the spoiler: 1. With the spoiler open end facing the rear of the case, carefully align the tabs of the spoiler with the notches on the case. 2. Insert the tabs into the notches and slide the spoiler towards the front of the case until it clicks into position Specifications: Size: 120 x 120 x 25.4 mm Rated Vol

Antec Enclosure Owners Instructions: