Epson FX-80 Technical Service Data

Text of the manual

PRELIMINARY SERVICE CHECKS

-This data provides the user with a time-saving service tool which is designed for quick isolation and repair of printer malfunctions. EPSON MODEL FX-80 o oo z >< °^ m QO Q.O Check all interconnecting cables for good connections and correct hookup before making service checks. Replacement or repair of the FMBD B

PRELIMINARY SERVICE CHECKS (Continued)

SERVICE CHECKS SEE INTERCONNECTING DIAGRAM AND PHOTOS TO MATCH THE NUMBER IN THE CIRCLES WITH THOSE IN THE FOLLOWING DATA FOR SERVICE CHECKS TO BE PER- FORMED. © 1.) PRINTER DEAD © © (A) Check AC Fuse (F1). If Fuse is open, disconnect the power transformer Connector CN6, switch the Printer On and check for 28.0V AC b

PRELIMINARY SERVICE CHECKS (Continued)

MECHANICAL REMOVAL AND REPLACEMENT RIBBON CARTRIDGE REPLACEMENT TIMING BELT REPLACEMENT Slide Carriage Assembly to center. Move Scale (5-28) to up- permost position. Turn knob on replacement Ribbon Car- tridge counterclockwise to tighten ribbon. Install Ribbon Cartridge with the two tabs at each end fitting into the two

PRELIMINARY SERWiCE CHECKS (Continued)

MECHANICAL REMOVAL AND REPLACEMENT (Continued) Holding Lever Assembly. Lift up the Scale and Paper Holding Levers to remove them from the side frames. Keep the two Lever Springs (5-21) (5-26) released at this point with the assembly. Reassemble in reverse order. FRICTION/SPROCKET PLATEN REMOVAL Perform Paper Feed Motor/

PRELIMINARY SERVICE CHECKS (Continued)

PRELIMINARY SERVICE CHECKS (Continued) pi IVAC \ 120VAC @ 450mA POLARIZED POWER TRANSFORMER T1 FILTER BOARD cni © POWER SWITCH SW1A ±1 AC FUSE 2A u)6b PAPER EMPTY r (8A SWITCH . SW99 ' - - IC1 16 19- CN1 7.6 VAC CN6 DB1 ?(1C —W- 28.0VAC (SB) • VP 24.0V MICROPROCESSOR 1C3B FMBD BOARD 1C) (4D) (5E) 18 JC2 (8B) 1 2 -

PRELIMINARY SERVICE CHECKS (Continued)

PRELIMINARY SERVICE CHECKS (Continued) @@@)(5E " ©@)@ oo ni T.9 00o FMBD BOARD V! FMBD BOARD V!!

PRELIMINARY SERVICE CHECKS fContlnued)

MISCELLANEOUS ADJUSTMENTS HEAD DRIVER PULSE WIDTH ADJUSTMENT Connect the input of a scope to pin 36 of the Micro- processor IC (3B). Set the horizontal sweep to .1ms, trigger to positive edge. Use the Printer self-test mode (hold LF Button down while switching Printer On) and adjust the Pulse Width Control (VR1) for a p

PRELIMINARY SERVICE CHECKS (Continued)

1.20VAC XL* v-:>; WW !' ... v-:-- 0:V .' ;ll , i. I 1 F1 POWER SWITCH AC FUSE ® FILTER BOARD

PRELIMINARY SERVICE CHECKS (Continued)

©(D w ji ;«g ::£ '•- Kg'

Other Printer Manuals