Codex AU-VCXRAW2 Getting Started Manual

1 Getting Started Guide Version 2.0 AU-VCXRAW2 Recorder for Panasonic VariCam Pure ...

2 Safety Warnings Please observe any warnings and follow all instructions. • Do not use this equipment near water and clean only with a dry cloth. • Install in accordance with the manufacturer’s instructions. • Do not install near any heat sources such as radiators, heat registers, stoves, or other equ ...

3 Contents Codex AU-VCXRAW2 Recorder - Getting Started 4 Introduction .....................................................................................................................................................................4 Further documentation ..................................... ...

4 Codex AU-VCXRAW2 Recorder - Getting Started Introduction The Codex Recorder (AU-VCXRAW2) integrates with the Panasonic V35 Camera Module (AU-V35C1) to make the VariCam Pure camera system. The system allows for uncompressed RAW capture at UHD or 4K at up to 120fps. The recorder attaches directly to the camera ...

5 Follow these steps to mount the AU-VCXRAW2 to the rear of the AU-V35C1: • Ensure the AU-VCXRAW2 is switched off and power is disconnected prior to installing the it to the AU-V35C1. • Lift the red release catch and pull the black lever on the side of the AU-V35C1 to prepare the locking mechanism. • Low ...

6 Loading and unloading a Capture Drive from the Recorder The door of the AU-VCXRAW2 is located on the top. Slide the release catch next to the door to open it. Insert the Capture Drive into the AU-VCXRAW2. The base of the Capture Drive should be oriented towards the front of the AU-VCXRAW2. Push the Capture D ...

7 Menu configuration The settings menu is configured as follows: [SYSTEM SETTINGS] Sets the system in general. Sets the system frequency, the number of lines, recording format, and recording method. [CAMERA SETTINGS] Sets the fine quality adjustment of camera videos and sets camera operation. This item is also ...

8 6. Turn the jog dial button to place the cursor on the desired item. 7. Press the jog dial button. - Setting is completed. 8. Press the button to close the menu. Setting menu initialization Select [LOAD FACTORY DATA] from [MENU] → [SYSTEM SETTINGS] → [INITIALIZE]. [MENU] setting values are reset t ...

9 Item Description of settings [CDL] Sets the grading process method when [GRADING] is set to [Internal] or [External App]. When [GRADING] is set to [Internal]/[External App]: [ON]/[OFF]/[SAVE AS(SD CARD)] When [GRADING] is set to [OFF]: [OFF] Factory setting: [OFF] [MON 1] Sets the output image from the

10 Item Description of settings [IMAGE INVERT] [MON OUT] Sets if the monitor output image is to be inverted. [ON], [OFF] Factory setting: [OFF] [VF & VF SDI] Sets if the output image from the terminal and the terminal is to be inverted. [ON], [OFF] Factory setting: [OFF] [INVERT SELECT] Sets the ...