Jasic Plasma Cut 80 Operator's Manual
Text of the manual
Plasma Cut Series
| Plasma Cut 60 (JP-61) | Plasma Cut 80 (JP-81) |
A WILKINSON STAR LIMITED PRODUCT 12-16 ISSUE 1
Your new product
Thank you for selecting this Jasic Technology, Wilkinson Star product.
This product manual has been designed to ensure that you get the most from your new product. P
A WILKINSON STAR LIMITED PRODUCT 12-16 ISSUE 1
SAFETY
These general safety norms cover both arc welding machines and plasma cutting machines unless
otherwise noted.
The equipment must only be used for the purpose it was designed
A WILKINSON STAR LIMITED PRODUCT 12-16 ISSUE 1
If ventilation is poor, wear an approved respirator.
Read and understand the Material Safety Data Sheets (MSDS’s) and the manufacturer’s instructions for
metals, consumable, coat
A WILKINSON STAR LIMITED PRODUCT 12-16 ISSUE 1
Always ensure machine covers and protective devices are in operation.
Precautions against fire and explosion
Avoid causing fires due to sparks and hot waste or molten metal
Ensure th
A WILKINSON STAR LIMITED PRODUCT 12-16 ISSUE 1
dangerous to the operator.
When the equipment is scrapped, it should be dismantled separating components according to the
type of materials.
Do not dispose of the equipment with norm
A WILKINSON STAR LIMITED PRODUCT 12-16 ISSUE 1
Unpacking
Check the packaging for any signs of damage. Carefully remove the machine and retain the packaging
until the installation is complete.
Location
The machine should be locate
A WILKINSON STAR LIMITED PRODUCT 12-16 ISSUE 1
Air pressure setting
The machine should be connected to a suitable air supply, 4.5-5 Bar pressure.
The embedded filter reducer is preset prior to leaving the factory, and users shoul
A WILKINSON STAR LIMITED PRODUCT 12-16 ISSUE 1
workpiece.), and then push the torch trigger. After the arc is ignited and started, raise the cutting
torch to the position about 1mm above the workpiece, and start cutting.
Controls
A WILKINSON STAR LIMITED PRODUCT 12-16 ISSUE 1
Panel Indicators
Symbol
Function
1
Power indicator. It illuminates when the machine is powered on, and it flashes
after arc is successfully ignited.
2
Overheating indicator. It illu