Neptune Apex PM2 Setup Manual
Text of the manual
Table of Contents
PROBE MODULE 2 – INTRODUCTION .............................................................................. 3
FEATURES ...................................................................................................................... 3
PHYSICAL INSTALLATION .............................................................................
Apex Probe Module 2 (PM2) - Setup Guide
Page 3
PROBE MODULE 2 – INTRODUCTION
Congratulations on your purchase of the AquaController Apex expansion accessory. The
AquaController Apex Probe Module 2 expands the monitoring and control capabilities of
your Apex system by adding conductivity and temperature probe ports. The
AquaController Apex System delivers a
Apex Probe Module 2 (PM2) - Setup Guide
Page 4
•
Mount all modules above the water line of the aquarium.
•
Be sure to utilize drip loops on all power cords, AquaBus cables and probe cables.
WARNING: Water damage will void your warranty! Mount all modules in locations
safe from moisture exposure.
INITIAL CONNECTIONS
Plug one end of the included AquaBus c
Apex Probe Module 2 (PM2) - Setup Guide
Page 5
Web Interface: Configuration – Module Setup – Verify the probe module is listed
in the Apex Module List.
UPDATE PROBE MODULE FIRMWARE
A new version of firmware for probe modules may be included with Apex Base Module
firmware updates. You should check the firmware version status when the probe module
is first
