Zhone SNE2040G-P Management Manual

Document Number SNE2-A2-GK41-00 November 2004 Overview The SNE2040-P (Provider) and SNE2040-S (Subscriber) units support SNMP management with firmware version 6.0.0 or greater. Paradyne also provides command line utilities that can be used to configure and upgrade the SNE2040 without SNMP. Command Line Utilities Three command line utilities are available on the Paradyne website. (Click o ...

Example: pdynips.exe 10.11.22.100 255.255.255.0 10.11.22.1 The program sets the IP Address, subnet mask, and the default gateway of the SNE2040. The SNE2040 will acknowledge the change if it is successful. pdynncl Format: pdynncl.exe nvram clear Example: pdynncl.exe nvram clear This program clears NVRAM on the SNE2040. The SNE2040 will be set back to the factory defau ...

units. You must download the latest Paradyne MIBs to your SNMP platform before you can fully access the SNE2040 units. There are specific MIBs written for the SNE2040 that need to be compiled into your browser. To set your IP address, subnet mask, default gateway, and in-band management, go to the following objects: Note: When you ch ...

3. Type: ARP -s 192.168.254.250 xx-xx-xx-xx-xx-xx where the IP address is the default address of the SNE2040-P and xx-xx-xx-xx-xx-xx is the MAC address you obtained from the label on the bottom of the unit. Note: If you are working on more than one SNE2040, you must to change the static ARP table entry before you can contact each unit. 4. Connect your PC to the Ethernet port of the ...