S&C SpeedNet Installation Instructions Manual

Installation Instructions TABLE OF CONTENTS Section Page INTRODUCTION Qualified Persons............................................................. .2 Read this Instruction Sheet. ............................................. .2 Retain this Instruction Sheet............................................ .2 Latest Document Release. ....... ...

Sheet Retain this Instruction Sheet Latest Document Release Warranty � WARNING The equipment covered by this publication must be installed, operated, and maintained by qualified persons who are knowledgeable in the installation, operation, and maintenance of local area networking and routing functions a ...

the SpeedNet Radio and software in accordance with S&C's applicable instruction sheets. This warranty does not apply to major components not of S&C manufacture, such as batteries, and other communication devices. However, S&C will assign to immedi ...

field installation steps that are specific to the SpeedNet Radio. Pre-Installation Checklist Before you install the SpeedNet Radio, carry out the following steps. This is best done in the shop before you leave for the installation site. 1. ...

route request has a sequence number tracked by the nodes, so that they will not repeat a previous route request. Route requests also have a time-to-live indicator, that restricts the number of times they will be transmitted. AODV also creates no route discovery ...

Subnet Mask 255.0.0.0, 172.16.0.0, Subnet Mask 255.240.0.0, and 192.168.0.0, Subnet Mask 255.255.0.0. These addresses are also notated 10.0.0.0/8, 172.16.0.0/12, and 192.168.0.0/16;. They can be used by anyone setting up internal IP ne ...

identified and allows frames to be marked for specific nodes. It thus forms the basis of most of the layer 2 networking upon which higher OSI Layer protocols are built, to produce complex functioning networks. 7 1072.510 OSI Model Data Unit Layer Function Da ...

network. The following example of a SpeedNet Radio network uses several private IP subnets from the 192.168.0.0 block of private addresses. The SpeedNet Radio network, depicted in Figure 1, contains three Ethernet segments. The first segment use ...

Ethernet subnets. Data is then routed between the Ethernet subnets. Route information can be entered manually, or can be processed automatically by AODV, the SpeedNet Radio algorithm. The type of network you are designing will help determine the best routi ...