Intermec PM23c Installation Instructions Manual

Intermec Technologies Corporation Worldwide Headquarters 6001 36th Ave.W. Everett, WA 98203 U.S.A. www.intermec.com The information contained herein is provided solely for the purpose of allowing customers to operate and service Intermec-manufactured equipment and is not to be released ...

3 Install the UART+Industrial Interface Board Use these instructions to install the UART+Industrial interface board in Intermec PM23c, PM43, and PM43c printers. You will find these items in the shipping box: You will need the following tools to install the interface board: • T20 Torx sc ...

Open the Printer You need to remove both the media cover and the electronics cover to install the UART+Industrial interface board. To remove the media cover 1 Open the media cover. 2 Use the small wrench to loosen the nut that secures the media cover latches in place. 3 Slide the latche ...

5 To remove the electronics cover 1 Use a T20 Torx screwdriver to remove the two screws that secure the electronics cover to the inside of the printer base. 2 Use a T20 Torx screwdriver to remove the two screws located on the outside of the electronics cover. 3 Remove the electronics cove ...

To install the UART+Industrial interface board 1 On the back of the printer, remove the two screws that secure the cover plate to the printer, and remove the cover plate. 2 Attach the spacer screw to the center of the printer main board. 3 Insert the UART+Industrial interface board into ...

7 5 Insert the single or dual option board cable into the 80-pin connector on the printer main board. 6 Insert the other end of the option cable into the 80-pin connector on the UART+Industrial interface board. Note: You may need to use the dual option cable to connect to the main board d ...

Everett, Washington 98203 U.S.A. tel 425.348.2600 fax 425.355.9551 www.intermec.com © 2013 Intermec Technologies Corporation. All rights reserved. 7 Install the jumpers and ICs on the board to configure it for the type of serial communication you want to use: 8 Replace the electronics cover. 9 Replace the media c ...