InterVac A900 Installation And Operating Manual

Text of InterVac A900 Installation And Operating Manual

RECORD THIS INFORMATION FOR

FUTURE REFERENCES MODEL NUMBER_______________________ DATE OF PURCHASE ___________________ PLACE OF PURCHASE__________________ Manual # M010 Date: 01-2015 INSTALLATION AND OPERATING MANUAL MODEL A900 with LED MODEL A910 without LED IF YOU SHOULD HAVE ANY QUESTIONS OR EXPERIENCE A PROBLEM WITH YOUR INTERVAC PRODUCT, PLEASE CALL OUR CUSTOMER SERVICE DEPT. AT: 1-888-499-1925 DO NOT RETURN THIS PRODUCT TO THE STORE OR DEALER This

The low voltage Control Wires from your Central Vacuum Cleaner

have mostly an output of 24volt AC. : some Central Vacuums have 24volt DC output. If your vacuum does not start --- just reverse the 2 wires at the wire nuts. (reverse the polarity). Note Installation: into a kitchen cabinet kick-board or room base board flush with the floor. IMPORTANT: DISCONNECT THE POWER TO THE CENTRAL VACUUM BEFORE INSTALLING WITH TRIM-PLATE INSTALL

Connect the 24volt wires from the Central Vacuum to the VacPort.

Leave slack in the wires at the connections. Please Note: The connection to the VacPort should be flexible enough so that you can pull the FLEXIBLE HOSE and central vacuums Low Voltage Wires out of the wall and connect both to the VacPort outside the wall. You have 3 option to connect to the VacPort: 1) with PVC cement glue the elbow to the pipe coupling and then to the VacPort, the other end

ATTACHING VACPORT TO AN EXISTING

REMOTE INSTALLED VACUUM #1 Elbow fitting, does not need to be installed. Used only in tight spaces. #2 Existing 2” diameter Flex-Hose or Vacuum Pipe. If you have vacuum pipe installed , run the pipe straight into the “T” (#4) #3 Black Threaded Coupling, 4 supplied. This coupling is screwed counter clock- wise into the 2” Flex-Hose, the other end attaches to a pipe fitting with a twist and push. Do not

InterVac Central Vacuum Systems Owners Instructions: