Huawei FT2260 Quick Start Manual

Quick Start Introduction Top View  Note: The figures are only for your reference, the actual shape and color of the product may differ slightly. 7 8 9 10 1 2 3 4 5 6 1 Power on/off switch 6 Antenna port ...

circumstances. Doing so may damage the device and negate its warranty. The port was designed for diagnostic purposes only; it is not intended for customer use. Rear View 1 2 3 4 1 Battery cover 3 Battery slot 2 Battery port 4 Wall-mounting brackets 2 Telephone port 1 ...

 Note:  If the ambient temperature exceeds the temperature allowed for charging, the device stops charging the battery.  If connected to the power adapter, the device automatically charges the battery and stops charging when the battery is fully charged.  Remove the battery if the device is not in use for a lo ...

1. Power the device off. 2. Connect the indoor antenna to the antenna port as shown in the following figure, and screw on the antenna until it is securely connected. Installing the Power Adapter Under normal operation, the Home Phone Connect is powered from an A.C. power outlet using the power adapter that is included with the device. ...

The device provides two telephone ports. The ports provide connection to a single telephone number assigned to the device by your service provider. 1. Unplug your telephone from your wall's telephone jack. 2. Do not plug Home Phone Connect into your telephone wall jack, this configuration is not supported unless you have ...

Press the button to power on the device. When the device is on, the power indicator will be blue.  Note: Press and hold the button for 1 second to power off the device. Activating the Device If your device has not yet been activated, please follow the steps below: 1. Dial * 2 2 8 from a telephone that is connected to the Home Pho ...

The following table describes your device’s status at any given time. Icon Indicator Status Voice mail Blinking Blue New Message Battery Blue Full Charge Blinking Blue Partial Charge Blinking Red Low Charge Signal Strength Both Blue Strong One Blue Moderate One Blinking Blue Weak Power Blue The device is on Making Calls 1. Befo ...

office number. Your Home Phone Connect will not ring until you deactivate the service. Airtime applies to forwarded calls even if you send the call to wire line telephones. To Activate Call Forwarding: 1. Dial * 7 2. 2. Immediately enter the phone n ...

location inside the premises to public service personnel. The GPS chipset embedded in this device will work best if the device is located near a window or other opening.  Note: While the Home Phone Connect adapter has a backup battery, if the landline dev ...