IEI Technology LS 1 Wiring Instructions

Text of the manual

LS 1 & LS1 with Mortise Lockset & Exit Device

Wiring Instructions Install Battery Pack Note: Use Only Alkaline Batteries. 1. Insert 4 AA batteries into holder (note polarity) 2. Connect the red/black wires from the Raceway to the Red/black wires on the battery pack. The 4 remaining wires are for the optional door switch,

LS 2/2P Mortise Lockset & Exit Device

Wiring Instructions Control Module & Battery Pack *Note: Use Only Alkaline Batteries. 1. Connect the Flex Circuit from the Raceway to Control Module (note orientation of cable). Make sure cable is fully seated. 2. Connect the red/grey wires from Control Module to the red/grey wires on the Lockset

Other Door locks Manuals