Hawk 220 Operator's Manual

MODEL 220 HAWK SCROLL SAW OPERATORS MANUAL READ THOROUGHLY BEFORE OPERATING MANUAL #HA 0987 ...

...

of the equipment. 2. Know where the controls are and how to oper- ate them. 3. Wear safety goggles, ear protection and mask in dusty operations. 4. Never allow unsupervised children to operate equipment. Never allow adults to operate the equipment without proper inst ...

threads of the blade tensioning rod at the bot- tom arm every 16 hours. WAX Ie •• " ~ .1{."I'o\}"!ntDo"' ••••..· OIL FIG.2 Table: Keep the table ...

3600 turns while cutting. The kerf left after a turn is approximately 1/2 the width of the saw blade. When you want to cut a point, simply turn the piece the desired amount while maintaining downward pressure on it. It is not necessary to cut past the point and then restart, like the normal procedure fo ...

two or more sides of the work piece. To do this, sim- ply layout a pattern on two adjoining surfaces. These patterns may be identical or different. After the pat- terns are laid out, choose which surface to saw first. It usually will not make any difference which surface you choose, but conside ...

_ PROBLEM Excessiveblade breakage POSSIBLE CAUSE Improper blade size for wood thickness Cutting too tight a radius for blade size POSSIBLE SOlUTION Select proper blade size. Increase blade size for thick wood. See Blade Selection Chart. Increase radius size or reduce blade size. Refer to Turns and Corners in Sawing Section. Install bla ...

_ Step 1: Release the earn-over handle (HA-74) by flipping it over. I ow place the "L" shaped quick change hold rod (HA-65) behind the upper blade holder (FA-45) by inserting it with the short- est end in the vertical position and the longer end facing the rear of the saw in the open hole on the top of the up- per arm. (Fig. ...

1. Disconnect electrical power supply. 2. Remove saw blade from saw (see blade changing). 3. Loosen and remove the two 1/4" countersunk socket head screws located at the front of the table. (fig. 12) 4. Loosen and remove the 1/4" bolt connecting the table to the CD-13 rear table support. Remove the table from saw. 5. ...

_ 1. Release blade tension by flipping earn-over handle up. 2. Loosen knob at the top of hold down arm. 3. Rotate foot counter-clockwise to blade. Slide blade through cutout at end of foot and center in foot. 4. Adjust to desired height. 5. Tighten threaded knob. 6. Tension blade. TENSIONING THE DRIVE BELT _ 1. Loosen the four ...