Heatmiser PRT-ETS Operating Instructions Manual

This thermostat allows you to select between 5 sensor modes. • Built in Air Sensor • Remote Air Sensor • Floor Sensor • Floor Sensor & Built in Air Sensor • Floor Sensor & Remote Air Sensor To select the correct mode for your system, please read pages 16-22 11/10 Revisio ...

2 Temperature Display 8 Setting the Clock 8 Comfort Levels Explained 9 Locking the Keypad 12 Temperature Override 12 Temperature Hold 13 Holiday 13 Heat On/Off 14 Clean Screen 14 Factory Reset 15 Optional Feature Setup 16-22 Error Codes 22 Wiring Diagrams 23-26 ...

Symbol Description Heat On Icon Shown when the heating is On Flashing when the optimum start is in operation Frost On Icon (Heating Off) Shown when the heating is switched off and is protecting against frost only Keylock Icon Shown when the keypad is locked Floor Temperature Reached Shown when the floor temperature is reached ( ...

A programmable room thermostat is both a programmer and a room thermostat. A programmer allows you to set “On” and “Off” time periods to suit your own lifestyle. A room thermostat works by sensing the air temperature, switching on the heating when the air temperature falls below the thermostat setting, and sw ...

temperature, and saves energy. The way to set and use your programmable room thermostat is to find the lowest temperature settings that you are comfortable with at the different times you have chosen, and then leave it alone to do its job. The best way to do this is to set low temperatures first, ...

overheating in other rooms by adjusting the TRVs. The time on the programmer must be correct. Some types have to be adjusted in spring and autumn at the changes between Greenwich Mean Time and British Summer Time. You may be able to temporarily adjust the heating programme, for example, “Override”, ...

2. Do read the instructions fully so that you get the best from our product. DON’Ts 1. Do not install near a direct heat source as this will affect the workings of the thermostat. 2. Do not push hard on the LCD otherwise you will damage the liquid crystal display and this is not repai ...

the front half of the thermostat. Place the thermostat front half somewhere safe. Terminate the thermostat as shown in the diagrams at the back of this booklet. Screw the thermostat back plate on to the back box Step 3 Re-connect the thermostat ribbon cable and clip the two halves together ...

SET = This is the temperature you are trying to achieve in your home. Floor = This is the temperature of the floor. When the thermostat is in air and floor sensing mode, the thermostat shows a “Floor” button. Pressing this allows you to view the current floor temperature – pressing ...