Icom IC-A24E Instruction Manual
Text of the manual
Thank you for purchasing this Icom product. The
IC-A24E/A6E VHF AIR BAND TRANSCEIVER is designed
and built with Icom’s state of the art technology and crafts-
manship. With proper care this product should provide you
with years of trouble-free operation.
IMPORTANT
READ ALL INSTRUCTIONS carefully and completely
before using the transceiver.
SAVE
FOREWORD .................................................................................... i
IMPORTANT .................................................................................... i
EXPLICIT DEFINITIONS ................................................................. i
SUPPLIED ACCESSORIES ......................................................
RWARNING! NEVER hold the transceiver so that the
antenna is very close to, or touching exposed parts of the
body, especially the face or eyes, while transmitting. The
transceiver will perform best if the microphone is 5 to 10 cm
away from the lips and the transceiver is vertical.
R WARNING! NEVER operate the transceiver with a
headset or other
CAUTION: DO NOT transmit without an antenna. Other-
wise the transceiver may be damaged.
Insert the supplied antenna into the antenna connector and
screw down the antenna as shown below.
DBelt clip
Conveniently attaches to your belt.
Attach the belt clip with the supplied screws as below.
NOTE: Use the supplied screws only
I Panel description
e
r
t
u
y
i
o
Microphone
Speaker
!6
!5
!7
q
w
!1
!0
!2
!3
!4
IC-A24E
!7
!7
IC-A6E
q BACKLIGHT SWITCH [LIGHT]
Turns the backlight for display and keypad ON or OFF.
w PTT SWITCH [PTT] (p. 9)
Push and hold to transmit; release to receive.
•“
” appears on the function display while transmitting.
e VOLUME [VOL] (p. 9)
Adjusts the audio level.
r TUNING DIAL [DIAL] (pgs. 8–12)
➥Rotate [DIAL] to select the desired
!1 CLEAR KEY [CLR•DEL] (pgs. 8–17)
➥Push to turn to the frequency mode, when mem-
ory channel, 121.5 MHz, squelch level setting or
beep tone setting is selected.
➥Push
, then push and hold [CLR•DEL] to
delete a recall frequency data.
➥Push to clear the entered comment of memory
name while programming.
➥Push to stop the sca