Godex MX20 Operation & User’s Manual

USER MANUAL User Manual Version Issue Date P/N : MX20/MX30/MX30i series : Rev. 1.1 : 2015.06 : 920-015211-00 Ver. 2.0 ...

001 002 2 Printer Setup 004 2.1 2.2 2.3 2.4 2.5 Battery Installation Paper Installation Battery Charging Belt Strap & Shoulder Strap Usage Wizard CD Standard Installation 004 005 007 008 009 3 Setting and Control for Operation Panel 015 3.1 3.2 3.3 3.4 ...

FOR AMERICAN USERS Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful in ...

Battery Safety Precautions MX20/MX30/MX30i USER MANUAL Make sure to review the user manual carefully prior to product use. Neglecting to heed the following instructions can result in battery overheating, combustion, explosion, damage and/or decline in performance and product life. 1. Do not allow water, seawater or moisture to e ...

1.1 Box Content Please check that all of the following items are included with your printer. Charge the battery for at least 3 hours before use. MX20 / MX30 / MX30i Mobile Printer  CD Including GoLabel software and MX series user’s manual.  MX20 / MX30 / MX30i Series Quick Guide  MX20/MX30/MX30i Series Lithium Battery  ...

1.2 Getting to Know Your Printer Device Overview Rear View  Battery Belt Strap Holes 1 Mobile Printer Top Cover Window Membrane Panel LCD Membrane Panel Open Button Interface Cap Shoulder Strap Holes MX20 Series MX30 Series 2 ...

RS232+USB Port Power Jack 1 Mobile Printer Platen Roller Label roll guide Tear BAR Thermal Print Head Top Cover Hooks Top Cover Hooks This RS232 & USB Port only support signal transmission, no charge function. ...

2.1 Battery Installation Make sure to charge the battery for at least 3 hours prior to first use. Insert the battery on the rear side of the printer, aligning the battery hook properly. Push the battery into the slot until you hear a clicking sound. Battery installation completed ...

2.2 Paper Installation The printer is set to Direct thermal transfer so no ribbon is required. Place the printer on a flat surface and press the button. Top cover opened. Label roll guide can be adjusted according to label roll width. ...

Pull the paper out and close the paper cover. Tear off any excess paper in the direction of the side of the printer. Insert the paper as shown in the image. * When you move label roll guide, try to force near its bottom. Note ...