FUTABA 9Z WC2 Getting To Know Manual

by: Futaba Service Center Service and Support Team SOME OF THE MOST COMMON QUESTIONS AND ANSWERS ON USING THIS POWERFUL RADIO SYSTEM. 9Z WC2 9-Channel System ...

features of the 9Z. It is a supplement to the very detailed instruction manual, and is not meant to replace it in any manner. Rather it is intended to provide some in-depth explanations and detailed examples to answer questions you may have about using your ne ...

I. Equipment Selection. Answering Common Questions A. Channels/Frequencies and Frequency Bands B. Modules/Receivers/Accessories and Synthesized Equipment C. Modulation, FailSafe and Resolution (512 vs 1024) D. Batteries: Charging and Cycling E. Training Equipment and Functions II. Programming Specifics A. Selecting the Correct Model Type 2- ...

A. Channels/Frequencies and Frequency Bands How do I change the frequency of my transmitter? Using a single-frequency module: To change the frequency when using a TK-FM non-synthesized module, with the transmitter off, remove the module and replace it with a module on the desired channel. (Note that you can even change trans ...

full length. Would I be better off using that transmitter antenna length instead of it fully extended? Each Futaba transmitter has been tuned so that it will get the maximum output with the antenna provided. The FCC certification was made with that antenna. ...

The TK module, which is designed specifically for the 9V and 9Z models, is an acceptable replacement for the TP module. The TP module, which is used in the 5U, 7U and 8U radios, should NOT be used in the 9 channel radios in place of the TK module. The TK module is specifically designed for the unique envi ...

My Campac shows an unused model. Why won’t it let me copy into that unused model? The incredible flexibility of the Campac can lead to programming mistakes. In this example, the modeler used the first conditions, which are intended to be individual models, as conditions in other models. Thi ...

voltage suppressors, noise suppressors, chokes or to take any other precautions? In general, there is no need for noise suppressors in current Futaba equipment.Some other brands’ current equipment do require this; however, Futaba does not. Twisting servo exten ...

If you have an FM (PPM) receiver, your transmitter must be set on PPM. If you have a PCM receiver, your transmitter must be set on PCM. To check which type of modulation (also known as pulse mode) your model memory is currently set for, turn on the transmitter. In the upper r ...

discharging VERY rapidly. As a result, by the time the Battery FailSafe (BFS) throttle warning occurs, it is very likely that you do not have sufficient voltage to support the receiver long enough to land/return your model to you safely. If you are usin ...