German pool SC-09 Operating Instructions Manual

掛牆分體式空調 SC-09 SC-12 在使用之前請詳細閱讀 「使用說明書」及「保用條例」，並妥為保存。 Please read these instructions and warranty information carefully before use and keep them handy for future reference. ( 附遙控器With Remote Control ) MODE ON/OFF FAN CLOCK BLOW TURBO SLEEP LIGHT TEMP TIMER ON TIMER OFF SWING FAN OPER C ON ...

should be forbidden. This symbol stands for the items should be followed ■ ..................................1 ■ ■ ................................11 ■ ....................................14 ■ ..........................20 ■ ...................................21 ■ ..................................23 ■ ..................24 ■ ...............25 ■ ■ ..................... ...

1 ★ ★ Be sure to pull out the power plug ★ ★ ★ ★ Earth: The ground be connected! If not, please ask the qualified person- nel to install. Furthermore, don't conn- ect each wire to the gas pipe, water pipe, drainage pipe or any other impr- oper places. when not using the air conditioner for a long time. Otherwise, the accumulated dust may cause fire or electric shock. Sel ...

If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard. The airflow direction can be adjusted appro- priately. At operating, adjust the vertical airflow direction by adjusting the louvers of upward/do- wnward direction. And then, hold two ends of left and right louver to adjust the horizontal air- flow. Lou ...

In "Heat" mode, under the following three kinds of state, if indoor heat exchanger doesn't arrive at certain temp., indoor fan will not act, in order to prevent cool wind blowing(within 2 mins): 1. Heating starts. 2.After Auto Defrost finished. 3.Heating under the low temperature. Gentle Breeze In the following situation, the indoor unit may blow gentle breeze, and the guide louver rotate to a certain position: 1. In “Heat” m ...

The operating temperature range (outdoor temperature) for cooling unit is 21℃~ 43℃； for cooling and heating unit is -5℃~ 43℃. Working temperature range Maximum cooling Minimum cooling Maximum heating Minimum heating Indoor sideDB/WB(oC) Outdoor sideDB/WB(oC) 32/23 21/15 27/--- 20/--- 43/26 21/- 24/18 -5/-6 Working temperature range Maximum cooling Minimum cooling Indoor sideDB/WB(oC) Outdoor sideDB/WB(oC) 35/24 21/15 48/30 21/- ...

⑸ ⑻ ⑶ ⑼ ⑴ ⑵ ⑹ ⑸ ⑵ ⑻ ⑼ ⑷ ⑺ ⑶ ⑴ Indoor unit Air in Air out Outdoor unit Wireless remote control Air in Air out Power cable Remote control Front panel Filter Guide louver Wall pipe Bind tape Connection wire Drainage pipe ⑷ ⑹ ⑺ ：Cool ：Dry ：Fan ：Heat ：Set temp. ：Run The pattern in displayer： 5 ...

in the displayer. When the LIGHT on is LIGHT button LIGHT set,the icon will be displayed and the indicator light in the displayer will be on. When the LIGHT off is set, the icon will be displayed and the indicator light in the displayer will be off. Names and functions of wireless remote control ● ON/OFF button ON/OFF Remote control Signal transmitter AUTO COOL DRY FAN HEAT (Only for cooling and he ...

Press this button, the temperature can be - button - set up, continuously press this button and hold for two seconds, the relative contents can quickly change, until unhold this button and send the order that the ℃ ( oF) signal will be displayed all the time. The temperature adjustment is unav- ailable under the Auto mode, but the order ...

remote controller sends the following three kinds of status that the swing status of main unit will be: When the guide louver start to swing up and down, if turn off the Swing, the air guide louver will stop at current position. which indicates the guide louver swings up and down between that all five positions. ●Press this button, to set up swing angle, which circularly changes as below: ●Press this ...

★ This function indicates that moisture on evaporator of indoor unit will be blowed after the unit About X-FAN function is stopped to avoid mould. 1. Having set X-FAN function on: After turning off the unit by pressing ON/OFF button indoor fan will continue running for about 10 min. at low speed. In this period, press X-FAN button to stop indoor fan directly. 2. Having set X-FAN function off: After turning off the ...

is locked, the icon flicker for three times. If the keyboard is unlocked, the mark will disappear. 1. Press swing up and down button continuously more than 2s,the main unit will swing back and forth from up to down, and then loosen the button, the unit will stop swinging and present position of guide louver will be kept immediately. 2. Under swing up and down mode, ...

or broken, please use the manual switch Auto mode, but the temperature and fan button. At this time, the unit will run at the To open the panel, the manual switch is on the displayer box. It's a special selective button for the users ,who are not accustomed to the light at sleeping. Get the displayer indicator light on: When setting the light function,the mark will pressing this button. In which case,the diss- pla ...

③ ① (a) (b) Clean and care Caution Turn power off and pull out the power plug before cleaning air conditioner, or it may cause electric shock. Never sprinkle water on the indoor unit and the outdoor unit for cleaning because it can cause an electric shock. Volatile liquid (e.g. thinner or gasoline) will damage the air conditioner. (So wipe the units with a dry soft cloth, or a cloth slightly moistened with w ...

② ③ Check that whether the batteries of air conditioner are changed or not. ④ Check that whether the installation stand of the outdoor unit is damaged or not. If damaged, please contact the dealer. ① ② ③ ④ ⑤ Clean and care Check before use Check that whether ground wire is properly connected or not. Maintain after use Turn main power off. Clean the filter and i ...

not operate in approximately 3 minutes to protect itself. ● ● ● ● ● ● Troubleshooting CAUTION Don't attempt to repair the air conditioner by yourself, it can cause an electric shock or fire. Please check the following items before asking for repair, it can save your time and money. Phenomenon Troubleshooting Not operate immediately when the air conditioner is restarted. There's unusual smell blowing ...

Has the power been shut down? Is power plug loosed? Is the circuit protection device tripped off or not? Is voltage higher or lower? (Tested by professionals) Is the TIMER correctly used? Cooling(Heating) efficiency is not good. Is Temp. setting suitable? Were inlet and outlet vents obstructed? Is filter d ...

Moisture on air outlet vent. If unit is running under the high humidity for a long time, the moisture will be condensed on the air outlet grill and drip off. Immediately stop all operations and plug out, contact the dealer in following situations. There is harsh sound during operation. The terrible odors emitted during operation. Water is leaking in the room. Air swi ...