Hirschmann BAT-C Operation & User’s Manual

Technical Support https://hirschmann-support.belden.eu.com User Manual Installation Industrial Wireless LAN Client BAT-C ...

2 The naming of copyrighted trademarks in this manual, even when not specially indicated, should not be taken to mean that these names may be considered as free in the sense of the trademark and tradename protection law and hence that they may be freely used by anyone. © 2017 Hirschmann Automation and Control GmbH Manuals and softw ...

3 Contents Safety Instructions 4 About this manual 12 1 Installation 13 1.1 Ethernet interface 14 1.2 Status indicators 14 2 Configuration 16 2.1 Using the WEB configuration 16 2.2 Two BAT-Cs Connected in Client mode 18 2.2.1 How to setup this example? 18 3 Flash Loader and Firmware upgrade 20 3.1 Advanced Mode 21 3.2 Flash Modes 21 ...

4 Safety Instructions ■ Important Information Notice: Read these instructions carefully, and look at the equipment to become familiar with the device before trying to install, operate, or maintain it. The following special messages may appear throughout this documentation or on the equipment to warn of potential hazards or to call ...

5 ■ Certified usage The device may only be employed for the purposes described in the catalog and technical description, and only in conjunction with external devices and components recommended or approved by the manufacturer. The product can only be operated correctly and safely if it is transported, stored, installed and assembl ...

6 ■ Housing Only technicians authorized by the manufacturer are permitted to open the housing. □ Verify that the electrical installation meets local or nationally applicable safety regulations. WARNING ELECTRIC SHOCK Never insert any pointed objects (small screwdrivers, wires, etc,.) into the product! Never insert sharp objects ...

7 ■ Lightning protection □ Note the safety instructions for lightning protection (see the datasheet for lightning protection or the WLAN Outdoor Guide). □ If possible, avoid installing in locations with a high risk of lightning. This applies in particular to installing antennas. The antenna should not be the highest point in t ...

8 □ trained or directed or authorized to switch on and off, to ground and to label power circuits and devices or systems in accordance with current safety engineering standards; □ trained or directed in the care and use of appropriate safety equipment in accordance with the current standards of safety engineering; □ trained in ...

9 This product may be operated in all EU (European Union) countries under the condition that it has been configured correctly. In accordance with the above-named EU directive(s), the EU conformity declaration will be at the disposal of the relevant authorities at the following address: Hirschmann Automation and Control GmbH Stuttgar ...

10 CAUTION Any changes or modifications NOT explicitly APPROVED by Hirschmann Automation and Control GmbH could cause the module to cease to comply with FCC rules part 15, and thus void the user's authority to operate the equipment. ■ IC Compliance Operation is subject to the following two conditions: 1. this device may not cause ...