ICM Controls SC 2300 Installation, Operation & Application Manual

Non-Programmable Manual Changeover SC 2300 Non-Programmable Electronic Thermostat Installation, Operation & Application Guide For more information on our complete range of American-made products – plus wiring diagrams, troubleshooting tips and more, visit us at www.icmcontrols.com • Up to two-stage heat / two-stage cool • Mercury-free, en ...

Parts Diagram .............................................................................................................................1 Specifications ..............................................................................................................................2 Important Safety Information ............................. ...

Cool/Off/Heat Switch Fan Switch Gas/Electric Switch Battery Compartment Celsius/ Fahrenheit Jumper RH ON AUTO 2300 F–C C Y2 W2 Y1 W1 RC G Up Button Down Button ...

• DC Power: 3.0 VDC (2 “AA” alkaline batteries included) Output: • Maximum: 1 amp per terminal (3 amp total for all terminals) • Temperature control ranges: 45°F to 90°F (7°C to 32°C) Accuracy: ± 1°F (± 0.5°C) • System configurations: Multi-stage – Two-stage heat or two-stage cool ...

labels, screws and wall anchors, Installation, Operation and Application Guide. Tools required for installation: Drill with 3/16” bit, hammer, screwdriver. Package Contents/Tools Required The SimpleComfort® 2300 is i ...

or switching the appropriate circuit breaker to the OFF position before removing the existing thermostat. 1. Turn off power to the heating and cooling system by removing the fuse or switching off the appropriate circuit breaker. 2. Remove cover of old thermostat. This ...

2. Move the FAN AUTO/ON switch to AUTO. 3. To remove cover, insert and twist a coin or screwdriver in the slots on the sides of the thermostat. 4. Put thermostat base against the wall where you plan to mount it (Be sure wires will feed through the wire opening in the base of the thermostat). 5. Mark the placement of the mo ...

suggest you change the batteries at least once a year, or whenever the LO BAT warning displays. Note: After installing new batteries, you have to reset the room temperature setting and the differential setting. Step 1: Move the Cool/Off/Heat switch into t ...