Fike SRX Installation And Maintenance Instructions
Text of the manual
INSTALLATION AND MAINTENANCE INSTRUCTIONS
Reverse Acting Rupture Disc Assemblies
Rupture Disc Models: SRX, SRL, Axius, ATLAS, AGT
Holder Models: SRX, SRL/SRLO, XL/XLO, ATLAS/ATLAS-LO
704 SW 10th Street · P.O. Box 610 · Blue Springs, Missouri 64013-0610 U.S.A. · (816) 229-3405 · www.fike.com
Page 1
06-251-1
WARNING
•
Rea
704 SW 10th Street · P.O. Box 610 · Blue Springs, Missouri 64013-0610 U.S.A. · (816) 229-3405 · www.fike.com
Page 2
5.
Check to make sure the gasket faces of the assembly are
flat by placing a straight edge across the face. If faces are
not flat, holder is not suitable for use (See Figure 3).
Figure 3 - Measuring for Flat
704 SW 10th Street · P.O. Box 610 · Blue Springs, Missouri 64013-0610 U.S.A. · (816) 229-3405 · www.fike.com
Page 3
Figure 6 – Pre-torqueable Holder
(TQ+ configuration shown)
10. Check gap between base and holddown. The gap must be
the same size on all sides of the assembly. This can be
assured by measuring the distance
704 SW 10th Street · P.O. Box 610 · Blue Springs, Missouri 64013-0610 U.S.A. · (816) 229-3405 · www.fike.com
Page 4
Appendix A – Stud Torque Values
NOTE: Torque values in Appendix A are based on a nut factor K= 0.2. Adjustment to the torque should be considered if the installation
utilizes bolting/lubrication with a nu
704 SW 10th Street · P.O. Box 610 · Blue Springs, Missouri 64013-0610 U.S.A. · (816) 229-3405 · www.fike.com
Copyright © Fike Corporation All Rights Reserved.
P/N 06-251-1-26 May, 2018 Specifications are subject to change without notice.
Page 5
NOTE: To
